1. When the switch is in the middle position, the LED lamp is in the closed state. The ac plug is inserted into the ac power of ac90v-240v and the charging indicator is on.
2. When the switch is in the lighting function of flashlight (the switch is facing up), 12LED flashlight lighting lamps are on above the LED light plate. At this time, the ac plug is inserted into the ac power of ac90v-240v and the charging indicator is on.
3. When the switch is in the emergency light function (the switch is downward), 52 LED lighting lights above the LED light plate are on, and the brightness can be adjusted by the appropriate strong and weak light. At this point, the ac plug is inserted into the ac power of ac90v-240v, the charging indicator is on, and 52 LED lights are off. At this time, it is in the charging state, with emergency function and no dimming function when adjusting the brightness switch. When the ac plug unplugs the ac power of ac90v-240v, 52 LED lights will automatically light up after 4 seconds and restore the previous function.

Directions For use:
A.T 0 turn ON 12 LED torch, push the 0 n/OFF button upwards till it touches the upper end, to turn OFF the push the ON/OFF button downwards in center position and turn ON all 52 LED Light, Push the 0 n/OFF button further downwards tiII it touches the lower end. T0 adjust the brightness of the Ultra bright LEDs,
Rotate the brightness control knobs in the direction advised on the knobs.
B. O charge the LED light, just open the plastic cover given at the back of the LED light. Unwind the charging wire, Plug the 220V pin in any standard AC outlet which in turn will charge the LED torch light.
C.T here is a small indicator near the LEDS chartered the status of the charge. Once fully charged unplug the wire from the AC outlet and wind it again & Place it at the same place of the LED light with plastic cover on top.
D.A void looking directly into the Led's as it has a strong beam.
E.C harge the torch only in OFF position or else it may damage the LEDs.