喷漆喷涂误区

Before spraying rocked the uniform can be, remember a wave tank, the tank body is glass beads, too hard, easily broken blocked nozzle, quality problem is not product.

Method of use:

1, before the complete removal of oil, paint parts water and dust.

2, use putty fill depressions and flat areas.

3, painting must be on shaking the jar for about two minutes, to paint liquidmixing.

4, in the first test plate on the small area of spraying, determine the accuracy of the selected color.

5, from the spray the surface of about 15-30 cm, with the index finger pressureand uniform spray nozzle.

6, repeat the steps, every 5 minutes to spray a thin layer, a better effect than.

7, the remaining small paint cannot be ejected, please be rotated 180 degreesand then spray nozzle. If not used up, before storing the paint cans upside down, press the nozzle about 3 seconds, cleaning the nozzle more than paint,to prevent clogging.

Matters needing attention:

? Please do not spray in direct contact with food objects.

? The unknown material surface, please small spray trial, after 10 minuteswithout adverse reaction, you can use.

? When spraying aerosol can and must keep with the horizontal surface shall not be less than 45 degree angle;

? Don't construction in the rainy days or freezing environment.

? If splashed into the eyes, rinse with water immediately, and see a doctor.

? On the children fail to get the position.

? This product is flammable, please store in less than 45 degrees, away from sources of heat and flame, no exposure, pierce or burn.

? Net and gross weight change with the passage of time, is a normal phenomenon of aerosol products, buckle consumption rate is less than 2%/.

Waste tank treatment:

Inverted cans in the old newspaper or waste tank pressure vent about 2 minutes to remove the remaining paint. In case of necessity, can move freely,clear.