Product Technical Parameters:

Pulse power: 350W

Sealing length: 270mm

Sealing width: 2mm

Heating time: 0.2-1.5 seconds

Dimensions: 300*160*115mm

This sealer is suitable for sealing various plastic films and can be widely used in food, candy, medicine, specialty products, chemical, electrical components, and other departments. It is a convenient and economical sealing equipment for factories, shops, and service industries.

Usage Method:

• This machine does not use a power switch. Insert the AC power cord into the outlet, adjust the heating time according to the thickness of the material to be sealed, place the plastic bag on the sealing surface, and then press the handle. The circuit will automatically control the heating time. When the indicator light goes out, the power will be automatically turned off. After about 1-2 seconds, release the handle, and the sealing will be completed.
• If the sealing junction breaks during sealing, it is because the heating time is too long. Please rotate the knob counterclockwise to shorten the heating time.
• If the sealing is not firm, it is because the heating time is too short. Please rotate the knob clockwise to extend the heating time.
• If the plastic bag is stuck to the rubber press plate, it indicates that the cooling time is insufficient. You must extend the cooling time after the indicator light goes out. Please wait a little longer before releasing the handle.
• After the heating time is set, it should be maintained unchanged when in use. No further adjustments are necessary when using it continuously.
• This machine can leave the power cord plugged into the power outlet at all times, and it does not consume electricity when not sealed.

Notes:

1. It is essential to maintain the sealing surface clean at all times to prevent the accumulation of residue that can oxidize and reduce the lifespan of the electrical heating tape and the heat-resistant fabric.
2. Do not use a wet cloth to wipe the sealing surface.
3. If the insulation under the electric heating belt is damaged, it will cause a short circuit and damage the electric heating belt. Therefore, when replacing the electric heating belt, it is necessary to check the integrity of the insulation. If there is any damage, a new one should be replaced.
4. When replacing the electric heating belt, it must be selected with the same specification as the original one.
5. Please check the rubber gasket after a long time of use, as the damage of the rubber gasket will affect the quality of the sealing.