Marine portable water - based fire extinguishers for ships

CE certificate for portable water base fire extinguisher ships

I. fire fighting principle

Fire extinguisher valve opens, the cylinder body of fire extinguishing agent in driving under the influence of gas pressure, the siphon from injection pipe, when the fire extinguishing agent with foamy physical effect after contact with the flame, so that the flame is extinguished.

Ii. Methods of use

1. When your fire, quickly pull out the latch, people stood in the upper position to live fire extinguisher, within the effective distance away from the fire, one hand hold injection pipe roots and flames in pushing down the (pressure pressed must be in place), the injection, can put out the fire.

2. When extinguishing, hold down the pressure handle of the fire extinguisher, and sweep the fire around according to the fire situation. Pay attention to the dead Angle to avoid reburning.

3. When using fire extinguishing, the head of the device should be facing up, and the tilt Angle should not be too large.

Iii. Matters needing attention

1. The fire extinguisher can only be used once. Once opened, no matter how much extinguishing agent is ejected, it must be refilled.

2. The fire extinguisher should avoid putting the cart before the horse in transportation, and handle with care during loading, unloading, and handling to prevent collision.

3. In order to ensure the normal use and personal safety of fire extinguishers, it is strictly prohibited to use fire extinguishers for playfulness and play; It is strictly prohibited for non-professionals to open and disassemble fire extinguishers at will.

Iv. Maintenance

1. The fire extinguisher place environment temperature should be between + 4 ~ 45 ℃, should keep dry ventilated, avoid exposure to the sun, strong radiation, so as not to affect the normal use of fire extinguishers.

2. The newly purchased fire extinguishers shall be inspected according to the following procedures and shall be inspected monthly thereafter:

Check the attachment of the fire extinguisher properly and firmly.

Check if the needle of the tester is in the operating area (i.e. the green area).

Garmin check no abnormality can be used after configuration.

Please contact the manufacturer or supplier for replacement if there is any abnormality during the inspection.

3. Fire extinguishers shall be inspected by trained personnel.

4. If it is found that the pressure gauge pointer is lower than the green zone during regular inspection, the drive gas (nitrogen) shall be supplemented immediately.

5. Fire extinguisher supplemental drive gas or maintenance shall be carried out in the professional maintenance department recognized by the fire control authority, and the maintenance conditions, procedures and quality shall meet the requirements of the ga95-2007 standard.