【 material 】: ash wood frame
[outer packing] : wooden frame packing
[color] : picture color (color can be customized)
[inventory situation] : the regular product customization cycle is 7-10 days, and the customized product customization cycle is 15-25 days, depending on the number of products and the production process.
[maintenance instructions] : wipe the cloth with detergent or neutral soap solution to remove dust, pay attention to the furniture can not be soaked in water, insolation, hard impact.

     Contact number: 0579-85190608 15958956969

     Contact number: 13735713828 Micro letter: 13735713828

     Micro letter: 15958956969

     QQ:   1178196503 

     Email address: shiyufurniture@hotmail.com

Supplementary explanation of process flow

 A, High temperature and pressure cooking, gas drying, steam chamber drying.  High temperature and high pressure cooking extracted the wood content of water and residual glue juice, steam drying makes the log to make furniture required moisture content, at the same time to achieve the effect of sterilization and insect control. After the treatment of the log will not deformation, moldy, rot and insect, the moisture content is basically below 12%. At this time, the wood surface with luster, uniform color and luster, texture, texture and texture to the middle.

 Two, dry treatment is the first step in furniture manufacturing, but also a key step. How to deal with it? -- steam drying treatment.  The drying process is divided into three steps:

  1. Preheating treatment: mainly low temperature and high humidity, so that the wood internal and external temperature balance, preliminary reduction of moisture content;

 2. Drying stage: gradually increase the temperature, slowly reduce the humidity, and extract the moisture inside and outside the wood to achieve the moisture content we want;

  3. Final treatment: after retreatment, the wood inside and outside is consistent and can be under normal temperature to eliminate the internal stress generated in the drying process. 3, machining 1, wood ingredients processing

    For solid wood raw materials that have been dried and processed, they shall go through: a: cutting/cutting materials; B: dig saw; C: planer/four-side planer/pressure planer; D: puzzle; E: cutting data/longitudinal cutting saw/guiding saw; F: milling machine; G :(copying) lathe; H: tenoning/drilling; I: broaching/carving/sanding. Plate ingredients processing: a: ingredients/wood veneer/patchwork/parquet; B: rough cutting/trimming/framing; C: cold pressure/hot pressure; D; Fine cutting/clamping sealing/trimming; E: coarse sand/fine sand; F: row/edge sealing; G: beat drill/bench drill; H: single end milling/double end milling; I: processing center/sanding/manual edge sealing.

 Do firm, sentence, close, flat, positive.

 (2) pay attention to the use of solid wood parts and wood tenon must strictly control its moisture content.

 (3) to each part of the bending deformation cracking and other adverse phenomena must be selected and processed.

 (4) pay attention to the panel, side board, door board, take out panel and other wood grain direction and pattern around the upper and lower pairing, color as far as possible consistent.

 (5) half of the group should check the mold, the file point is loose, wear.

 6, the group can not be installed when the reverse, wrong, nail, lock crack, dislocation and other adverse phenomena.

     Contact number: 0579-85190608 15958956969

     Contact number: 13735713828 Micro letter: 13735713828

     Micro letter: 15958956969

     QQ:   1178196503 

     Email address: shiyufurniture@hotmail.com