Usage: hand point flame gun
1 First, rotate the fire control knob clockwise to confirm that the air valve is completely closed.
2 Press down the bulge part of the lower connecting cover of the blow torch to the notch position of the cylinder, and then turn the blow torch body to the right (1/8). Blow torch is tightly fastened to the gas cylinder. (At this time, check whether there is gas leakage; Whether the connection between the gas cylinder and blow torch is correct. If leakage is found, please unscrew the gas cylinder, remove the foreign matter at the joint, and reinstall it. If there is still any leakage, please stop using it and replace gas appliance with the distributor.)
3 after use, tighten the fire control knob clockwise, and the blow torch will go out naturally. Confirm that the air valve has been completely closed. After the blow torch is fully cooled, rotate the blow torch body to the left and pull it up, remove blow torch and gas tank and place them in places far away from the fire source.

2. Blow torch when ignition 1 is ignited, the gas tank should be in an upright state, rotate the fire control knob 1/4 times counterclockwise, and press the ignition button to ignite. 2 The size of the fire power can be adjusted. If the adjustment knob is rotated counterclockwise, the fire power will be enhanced; If it is rotated clockwise, the fire power will be reduced. 3 after ignition, the gas cylinder should be kept upright within 1-2 minutes, and be careful not to shake it hard, otherwise there will be a danger of sudden increase of flame.

Three blow torch flameout 1 turn the fire control knob clockwise until the air valve is completely closed, and the flame is completely extinguished. 2 after the flame goes out, the blow torch is still in a high temperature state. Do not touch it with your hands. After it is completely cooled, remove the gas tank and put it in a safe place for storage.