LED Flexible Neon LightsAdopting high-brightness SMD 2835/5050 as the light source, flexible dual-sided 35-copper FPC as the PCB board, food-grade environmental silicone anti-UV material, it integrates the traditional neon light strip technology to become a new generation of high-tech products.

Product Advantages:

1. Flexibility, can achieve no dead angle bending, free modeling, particularly suitable for square corners, circular and irregular shape decoration.

2. Easy installation, DC12V/24V, SMD2835 LED chips, minimum spacing of 1cm can be cut, after cutting, the wire is directly soldered to the FPCB, and then installed after the tail plug is fitted and the glue is applied.

3. Long service life, with high-brightness copper-base lamp beads, high color rendering index, low light decay, and a service life of up to 25,000 hours;
4. High water resistance rating, food-grade eco-friendly pure silicone, anti-cold, resistant to yellowing, flame-retardant, and the water resistance rating can be up to IP68, suitable for installation in outdoor environments with water.

1. Low-voltage light strips must be used with a 12V/24V transformer power supply. Do not directly connect to 220V voltage, or the light strip will be destroyed.
Due to the damage caused by incorrect voltage connection and cutting, the product is not eligible for return, exchange, after-sales warranty, or service.

2、Light strip 1 piece = 1 roll = 5 meters, the price is per meter (excluding transformer, which needs to be purchased separately). Once the product is cut and sold, there will be no quality problem and no return or exchange will be accepted for any reason.

3. Low-voltage light strips with 12V should not be connected in series for more than 5 meters, and those with 24V should not be connected in series for more than 10 meters. If you need to install longer lengths, please use parallel wiring.

4. LED strip chips are relatively fragile, so installation should be careful. Do not bend them forcefully more than 90 degrees, as this may easily damage the LEDs. At corners, it is recommended to weld sections separately, and for small-sized aluminum channels, insert them from both sides.