【Carving Sticker Application Method】Tools: cloth, scraping board or credit card
1. Spray Wet Adhesive Method

1. First, clean the area where you want to apply the sticker. Spray water on the sticky side of the sticker with the backing paper removed. This will reduce the adhesive to make it easier to adjust the position and smooth it out.

2. When applying the sticker, do not remove the transfer film first. First, remove the backing paper from the adhesive side of the sticker tape. Do not remove the transparent transfer film on the surface. Note that you should flip the sticker over so that the backing paper is facing up. Then, slowly peel the backing paper from one end, bit by bit. If the backing paper and the film stick together, press down on the backing paper with your hand, and use both hands to pry it apart; let the film and the surface transfer film stay together without sticking to the backing paper. After removing the sticker, spray some water on the adhesive side of the sticker and some water on the car body. This way, it will be easier to adjust the position without sticking.

3. After sticking to the car body, use a scraping board to scrape all the water inside completely clean. After the adhesive is dry, peel off the transparent transfer film from the surface, and peel it slowly and bit by bit.

4. When removing the transfer film, do it slowly, with both hands working together. Gently and without pulling too hard or too fast, as this can easily damage the film. Then, use a blow dryer to heat the area to ensure that the film adheres completely to the vehicle body. Do not use too high a temperature, as this can cause excessive baking.

5. Many people don't understand how to stick the stickers. If they can't stick them well, they will say that the stickers are not easy to stick. If you really can't stick them, take them to a decoration store or a car washing shop and let the master who sticks the film do it. If it is very cold in the north with ice, if it is suggested that it will freeze immediately after spraying water, it is recommended to wait for better weather to stick. Or find the right position in one go and heat it with a blow dryer after sticking.

6. If the door seam position can be pasted well, use a little bottom paper to separate the body, and then cut the sticker with a knife. Use a blow dryer to heat the door edge and press it with your hands.