Product parameter 产品参数 "Name": the companion Dynamo LED emergency escape lighting in-vehicle emergency hammer breaking artifact "model": HQ-1057 , "lamp": 3 High Brightness LED "brightness": each brightness 11000mcd "Dimensions": long 15.2x wide and 8.3x high 3.3CM "weight": 163g "power": the rechargeable lithium-ion battery LIR2032-3.6V,40mAh

I. Overview
this product is a compact, portable lighting to save yourself an escape tool is especially suitable for various types of vehicles. Products main by lithium battery powered, in battery capacity low situation Xia, can repeatedly charging 500 times; in emergency State Xia, also can hand charging (built-in DC motor), hand a minutes (2 go/seconds), can for three a LED bright 8 minutes above, brightness (illuminated) reached 123LuX (distance according to degrees instrument 0.5M). battery full load Shi, discharge time not is less than 2 hours. Appliance is equipped with a blade to cut off belts, iron cones can break Windows to escape.

II. technical characteristics:

Overall dimensions: 152mmX84mmX33mm
body weight: 200g
LED3 diameter 5 round white whitish diode brightness 11000MCD, life of 100,000 hours.

III. operation and use:

When this product is used, simple operation, if wrenched the handle in one hand and holding another hand to stop wheel in order to shun or counterclockwise 2 revolutions per second, charge the internal battery, and after recharge, press the switch lighting. In case of emergency can put the safety belt into the slot in the blade, pull back and forth can cut off safety belt. Available iron awl knocking shards of glass. Products using soft rubber locking switch, click 3LED fight.

IV. Notes on use:

Dynamo charging, switch should be off. Hand hard as evenly as possible (keeping speed balance) and turn off the LED, too slow it will reduce the current extended charge time, too hard and too fast can damage the transmission components. When rotating the handwheel note hand gesture, to avoid injury to the nail and finger. Little children do not play with the appliance to avoid products that came with the blade and iron awl to scratch the body.

 
V. repair and maintenance: the product repaired by professionals

Daily maintenance:

1. do not leave the product placed in a hot and humid environment for a long time, so as to avoid circuit board gets wet, rusty blade.
2. in order to extend the life of the rechargeable batteries, empty shake once a month at least (for not less than 1 minute)
while 3.LED Dim, turn off the LED, to avoid excessive battery discharge.