"Product name": personalized reflective safety warning decals/bumper stickers

【 产品材质】：胶片

"Product": 20*8CM packaging, products: 20*5*0.1cm

"Packaging": single piece

"Product features": the
United States of 3M refined from reflective bumper stickers. the products remain bright 3-5. modeling reflective stickers, stickers on the rear, not during the day glow in the night, Stand out in reflective under light irradiation effect is very beautiful, but caution keep the distance. personalized, come and have a try now!

"Installation":
1. clean the car where you want to mount, and use a clean towel to wipe to dry.
2. direct sticker paper torn off, affixed to the location you want to mount, and scraper (or credit card) to scrape.
3. carefully transfer the sticker on top of the membrane is removed.

A "tip": the stickers onto the paint seems to be very easy to work with, but to put things straight and smooth but not so easy, especially when posted large patterns. If we then tore up the whole back in the car, first of all it's easy to fingerprint, second sticker adhesion to each other, and are difficult to control, and if the direction was wrong to pull up then stick stickers, possibly because the stickers were too soft and stretched it. We should start from a corner of the sticker, back post set off a small part (you can cut this part out if necessary),
principle of the stickers are attached from the inside out, and is labeled in the Middle, then pressed outwards with your finger, so you can launch bubbles. If from the outside Interface, and bubbles run out (at this point for the sake of appearance can bubble parts cut with a knife). Another method is to first apply SOAP on the body of water, so that the stickers don't stick died on the axle, you can adjust the position, discharged or squeeze the bubble from the middle to the edge. Soapy water is after half a day to dry, the process, do not touch it, after dry sticks very firmly.