Don't worry when your car can't reach you because it has no electricity. Take a taxi from the side of the road.

The procedure of connection is as follows:

(1) first place the red wire clamp of the starting line on the red battery anode of the \"rescued vehicle\".

(2) the red wire tongs at the other end are then placed on the red battery anode of the rescue vehicle.

(3) place the black wire tongs on the black negative battery of the rescued vehicle.

(4) then place the black wire tongs on the black anode battery of the rescue vehicle.

(5) start the engine of the rescue vehicle first, and then the engine of the rescued vehicle. If the rescued vehicle is still unable to start, please check the metal contact part for poor contact. After starting the engine, you still need to remove the starting fuse in order, otherwise it may cause a short circuit.

 The procedure for dismantling the wire is as follows:

(1) first remove the black wire from the rescued vehicle.

(2) remove the black wire of the rescue vehicle.

(3) then remove the red wire of the rescue vehicle.

(4) finally remove the red wire of the rescued.

 [matters needing attention]

1. Strictly follow the operation steps.

2. Check the labeled voltage of the two batteries and make sure the voltage of the two batteries is the same.

3. Close all the load on the vehicle, put in the neutral position, pull on the hand brake and start the engine. Smoking is prohibited near vehicles.

4. If the car battery has frozen, do not start it, or it may cause explosion.

5. Please ensure correct polarity of battery connection.

6. During operation, the car shall not be in contact with other vehicles.

Batteries produce explosive gas! Please wear a protective eye mask when installing the cable.

8. If the acid in the battery leaked by accident and spilled on the skin or eyes, please immediately flush with plenty of water, and then ask the doctor for help.

[environmental conditions] :

The battery line can work continuously and reliably under the following environmental conditions:

1. Air relative humidity should be less than 85%.

2. No wires, explosive dust, corroding metal and damaging insulating gas at the place of use.

3. No vibration and shock at the place of use.