Insert the receiver (receiver = a liquid crystal display) with a sensor (sensor = sensor emitter inserted into the soil) into the battery
Pool into the receiver, all the LCD subtitles will open for 4 seconds, the screen will display the outdoor received signal signal icon (upper left corner),
Indicates that the receiver is looking for a sensor signal. Do not press any key at this time, which interrupts between the transmitter and the receiver
Paired the process, and then the sensor into the battery, into the battery after the sensor power indicator light will be lit for about 20 seconds,
The sensor will first issue temperature and air readings (this is the lowest reading). If the receiver successfully decodes the sensor data
The sensor temperature and soil moisture readings will be displayed. Outdoor temperature and soil moisture data display for 3 seconds. In the automatic completion of the
, The matching process will take 400 seconds. If the key is pressed before the receiver receives the sensor reading, the pairing process will be terminated and
It takes 10 minutes before the receiver re-synchronizes with the outdoor sensor. If the receiver or transmitter needs to be reset, take the battery
And wait for 10 seconds, then re-put the battery to re-match. After the pairing process is complete, insert the sensor into the monitor
The location of soil moisture. The depth of the sensor should be 8-10 cm below the soil surface. Make sure the sensor is around the soil
Close, because the sensor is most sensitive to the soil into which the soil is exposed. The sensor is inserted into the exposed part of the stone
Or voids will affect the accuracy of the reading. Since the probe is sensitive to the dielectric constant, be careful not to contain metal in the soil
Install the sensor inside or near. Before the sensor is inserted, the water is poured into the soil until the surface is flashing, no more water can penetrate
Through (at this time represents the water content is 100%). At this time and then insert the sensor, the sensor will detect the maximum water content (100%), about 4 points
Clock Receiver LCD shows the highest water level: 99% (Note: "show water content of 99% of the data" for the actual watering water containing
The level of average data, which only means that this is the most water content rather than the exact water content ratio.
Insert the sensor should be careful to avoid being inserted in direct sunlight, because the direct sunlight will cause high temperature readings.
The frequency of the sensor data update is about 90 seconds, the soil after watering due to sensor transmission out of the reading requires four kinds of data, four kinds of data
Are consistent when the reading will be sent to the receiver. So the soil after watering the data update will be delayed, updated before the typical
Time between about 4-5 minutes.