The suit needs to add 10 m rolls, and the 30 m model is out of the shelf;

the width 10cm = 290g 15cm = 440g 20cm = 580g

below 30 m length rhino leather m

[Color]: Transparent

[Size]: 30m

[Material]: polyurethane film

[Packaging]: None

[Note]: the actual 21-22 m of this product is not enough   

at present, many car door interior of cars are light colors. When entering and leaving cars, it is inevitable that shoes will be rubbed or other hard objects will be encountered. It is most likely to be dirty or even scratched. Leave ugly dirt or scratches. In the past, many car owners were worried that these plastic places could not be cleaned. Due to the accumulation over the years, how to clean them looks dark, which is extremely out of proportion to other locations in the car.

 
This product is made of polyurethane film (commonly known as rhino leather) and has Rhino leather-like strength and toughness. It can protect plastic plates in various parts of the car and has material ductility, transparency and curved surface adaptability. Self-adhesive on the back, attached to the car door panel interior. After installation, it gets dirty and can be cleaned as new as long as you gently wipe it. Product installation:
first, clean all the dirt to be pasted with alcohol or foamed cleaner. If there is wax on the surface, wash it with boiled water and hot water above 60 degrees (important).
Second, compare the film with the shape of car door interior and cut off the extra parts,
third, tear the mucosa and stick it on it. If there is any uneven place, pull it aside by hand, then heat it with a hot air gun (or hair dryer) and press it gently.
Fourth, please go to the professional place of automobile decoration for construction.

Matters needing attention:
first measure the length of the attached part (for example, 90cm); Cut the required product length 92cm, (it is better to cut out 1-2cm more); remove reversed adhesive paper of the cut-length product, align the upper side of the part to be pasted first, and smooth it. If it is not aligned for the first time, you can peel it off again and paste it again; Finally, cut off the excess products on the left, right and lower sides of the pasted parts, and then smooth them. In case of Radian, cut the product from the middle and press it. It is best to ensure that the product is attached to the attached part, very simple! (In winter, it is better to use a hot air blower to bake it and stick it more firmly)