Pneumatic nail gun F50B

F nail can be up to 5mm, gun Volume 55*250*270,mm,1.43KG

100PCs (1.55 mm-50mm can be put on)

instructions for use:

1. This staple gun is used for wooden filament plate, old wood, building templates and other wood recycling operations.

2. Before use, drop a little lubricating oil from the pipe joint, and the pipe joint is connected with compressed air.

3. It is suitable for pushing and unloading of a single nail and fixing various connections without or restricting continuous nailing.

Note:

1. Only compressed air can be used, and the working pressure must not exceed 0.8MPa;

2. It is strictly forbidden to use flammable and explosive gases such as oxygen, and it is strictly forbidden to use high-pressure air compressor as the power source;

3. Before use, make sure that the pressure gauge of the air compressor is correct and reliable, so as to avoid damage caused by over-pressure use;

4. Wear goggles and protective gloves when using staple gun to ensure the safety of operators;

5. When nailing, remove the air connector and cut off the air source;

6. It is strictly forbidden to point the gun head to yourself or others to avoid causing harm;

7. During operation, it is strictly prohibited to be close to flammable and explosive products, and do not work in harsh environments such as corrosion, corrosion and dust;

8. Don't knock and touch at will, don't empty the gun at will;

9. If a fault occurs, disconnect the air source immediately, take out all the nails in the clip and repair it.