Wool polishing tray with polishing tray suitable for rough grinding and polishing wax

For more details:http://www.yiwugou.com/hu/0568819.html

Product description:
This product can produce fast surface cutting effect with special wool material and polishing machine.
It is more convenient to use a smooth surface with a smooth surface after use.

Suitable for large area medium ground grinding, the specification is 230*35mm, with polishing tray.

Product features: good toughness, strong wear resistance.

Suitable for use: automotive paint finish, ceramic, stainless steel, furniture finish and other finishes.

Instructions:
1. Suitable for waxing, polishing and glazing.
2: pneumatic or electric polishing machine can be used.
3. When the product waxes, it is recommended to use 1000-1500 RPM.
4: when polishing the product, it is recommended to use 1500-2000 RPM.
5. When cleaning products, only use cold water 15-25 degrees.

To ensure the polishing effect, the vehicle must be thoroughly cleaned before waxing.

It can be divided into two kinds: manual waxing and mechanical waxing. The wax is simple and easy to use, and the wax efficiency is high. Whether by hand or mechanical waxing, make sure the paint is evenly applied. The wax by hand, you will right amount daub wax wax (special sponge) on the sponge, and then according to certain order reciprocating linear daub, each daub should with the daub on regional 1/5 - a quarter of the coincidence degree, prevent leakage and ensure evenly. When the mechanical wax wax coating on the polisher sponge, the specific process and manual daub is similar, it is worth noting that in edge, Angle and edge daub should avoid out of paint, in respect of this manual apply easier to grasp.

When polishing. According to the instructions of different car wax, it can be polished after 5 to 10 minutes. Follow the principle of first waxing polishing polishing, to ensure that the car after polishing table is not contaminated, the polishing process usually use non-woven fabric hair reciprocating linear motion, you push hard on the appropriately, in order to please in addition to residual wax.

The following questions should be noted when polishing and waxing:
1. The waxing work environment is clean and well ventilated, and there are conditions for setting up a special waxing workshop.
2. The car should be waxed in the shade, otherwise the car's surface temperature will be high, and the wax attachment ability will decrease, which will affect the waxing effect.
3. When waxing, the manual sponge and waxing machine should be used in a straight line, which is not suitable for circular smear, which can prevent a strong circular diffusion due to uneven coating.
4. Waxes should follow the principle of first, first apply the roof, front and rear cover, body side and so on.
5. When the wax is waxed, if the paint is the same color as the car, it may be that the paint has been damaged, and the wax should be stopped immediately and repaired.
6. The polishing work should be done in time after the wax is finished, and the polishing movement will be reciprocated in a straight line. The unpolished vehicle will not be allowed to drive on the road, otherwise it will be polished and will cause the scratch of the paint.
7. After finishing the polishing, it should be carefully checked to remove residual wax from the license plate, headlamp and door, so as to prevent corrosion.
8. After the wax is finished, the equipment and supplies should be properly cleaned and properly stored.
9. To mastering the frequency of wax, because the car and park environment is different, waxing time interval is on track, but can use hand wipe the body paint, if not smooth feeling, should be waxing again.