Electric welding gloves is a kind of manual welding gloves, which can provide safety protection and comfort for workers. At present is mainly two layers of leather, pig skin, sheepskin and other natural leather made.

Features: mainly heat insulation, wear-resisting, prevent spatter scald, block radiation, at the same time a certain insulation performance.

There are two types of welding gloves:

1. Ordinary manual welding gloves so-called manual welding, is our usual common

A pair of pliers for this welding of the electrode. This kind of welding high temperature splash many. So the gloves are mostly double layers of Gary's. The length is also over 35CM

2.Argon arc welding gloves

This kind of welding spatter is few, but the temperature is high, radiation is strong, welding wire is thinner. So this kind of glove feels better

Ok, it's thin. It's not too long.

EN12477: type A, type B

Conductivity / 10 ^ 6 or higher insulation resistance ohm resistance 10 ^ 6 ohms resistor or greater

Wear resistance 500 times 100 times

Resistance to cutting index 1.2 index 1.2

Resist tearing 25 Newton 10 Newton

Puncture resistance 60 n 20 n

Anti-burning level 3, level 2

It's 100 degrees Celsius, 100 degrees Celsius

HTI is greater than or equal to 7

Anti - fine metal slag 25 grain 15 grain

Dexterity (diameter of nail) is no more than 11mm or 6.50mm

Matters needing attention

Note the following 10 points when using gloves

1.Choose gloves suitable for different workplaces. Gloves should be of appropriate size. If the gloves are too tight, blood circulation will be limited, which will cause fatigue and discomfort. If too loose, the use is not flexible, and easy to fall off.

2. The selected gloves shall have sufficient protective effect. For the environment of steel wire anti-cutting gloves, synthetic yarn anti-cutting gloves shall not be selected. To ensure its protective function, gloves must be changed regularly. If the use period exceeds, it is possible to cause hand or skin injury.

3. Inspect the gloves at any time to see if there are any holes or damaged or abrasion areas, especially the joints of the fingers. The gassing method can be used to check the chemical protective gloves.

4. Pay attention to the use of gloves. If a deputy is used in different places, the service life of gloves may be greatly reduced.

5.Safety should be paid attention to in use, do not throw the contaminated gloves at will, and avoid causing harm to others. Keep the unused gloves in a safe place.

6.The correct method must be paid attention to when removing the gloves, so as to prevent the harmful substances on the gloves from touching the skin and clothes and causing secondary pollution.

It is best not to share gloves with others, as the inside of gloves is a breeding ground for bacteria and microorganisms that can easily cross over.

Wash your hands before wearing gloves. Keep the gloves on clean (sterile) hands, or they will be prone to breeding bacteria. After removing the gloves, wash your hands and apply some hand cream to replenish the oil.

9.Cover the wound before wearing gloves. The skin is a natural barrier against environmental damage, preventing the entry of bacteria and chemicals.

10.Do not ignore any erythema or itch to prevent skin diseases such as dermatitis. If the hands appear dry, itching, air bubbles, etc. to consult a doctor in time