Product features:

1 the appearance of the product with the original logo, installation can directly replace the original factory logo at the rear of the vehicle logo location box. The special vacuum plating technology, not only guarantee with the original logo gloss consistent, can guarantee the high transparency and brightness uniformity.

2 high quality LED lamp group, has the characteristics of high brightness, long service life, special design waterproof, dustproof, ensure the long time use.

3 this product is specially designed for car enthusiasts and special design, logo lights during the day does not shine, and there is no difference between the original logo, license plate lamp at night after opening the LED logo lights will come on, to become Its brightness dazzles the eyes. logo in the night, full of sense of future science and technology, show your love car noble lineage

5 LED lamps using special waterproof and dustproof design! LED lamp life of up to 100000 hours!

6 uses the high quality special double-sided auto glue, adhesive force strong persistence!

!

Please order your message type and need logo light color, thank you!

[size] 10.5cm (diameter)

[color] red white blue, one of three

[source] DC12V+/-10%

[] wiring length 0.6 meters

[power] 2 (W)

[voltage] 12 (V)

[current] 0.1 (A)

[instructions]

Please prepare the following tools before the start:

1 flat head screwdriver 2 cross screwdriver 3 insulating tape 4 towels, 5 pliers

Open the packaging, this is the mass of the car light, come have a look after the light effect, red light warm warm, very conspicuous and eye-catching wild

The first 1 beside the tail box logo with a towel, with a slotted screwdriver pry logo, shop towels to prevent scratches the body

2 note first the double-sided adhesive strip body, moderate force when prizing, too hard, one point one, slowly on the lever down, clear logo and double-sided adhesive on the body

3 use a Phillips screwdriver to remove the tail box clapboard, pay attention to some places with the clip, careful operation removed sound insulation board can see all kinds of line.

4 now installed car lights, logo lights power line through which a vehicle logo location hole, wear to the carriage

Tear off the light back single-sided adhesive, side pull side of the car lamp glued to the body, pressing.

5 logo lights installed, now connected to the power supply. Car lamp to lamp power supply is connected with the rear license plate, such as opening night light car lights will be open at the same time, the power connector license plate lamp found

6 unplug the plug, positive and negative pole each strip a cut, expose the electric wire core, according to red to red, black on black connection, don't forget to use insulation tape wrapped, and finally to the plug back! Install back tail box cover panels!