"Product name" mini jewelry scales

"Product number" ATP188
"material" stainless steel + plastic
"colour classification" figure
"product" 7.5*5*1.4CM

"Scale dimensions" 3.8*4CM

"Product range" 200g
"precision" 0.1g

"The units"g CT oz DWT
"batteries" 2, 7th battery
"product accessories" jewelry scale 1, or English instruction manual 1

Key features:

1 power on/off t Peel zero m unit conversion p count (user manual)

First, the instructions: put the battery in battery compartment indicates the correct mounting, place the scale body in steady, wind-free table.

• Press power button to boot, wait three seconds to 0.1 or 0.01;
• Will have to weigh items on the scale, numerically stable readings;
• Press the unit key to change units of measure;
• Power on press power button off.

Second, the deduction/peeling

• Boot as described above;
• Place the buckle weights on the scale;
• Press Peel display 0.1 or 0.01, indicates a deduction;
• Then add the items to be weighed, and readings is the net weight of the items.

Third, correction

1, power on go to zero;

2, press the unit conversion button until CAL appears, press the unit conversion button, then flashing weight value.

3, place the appropriate weight in scale Central, later, show PASS, and then display the weight value, calibration is complete, after you remove the weights, you can carry out weighing.

Four, troubleshooting

Weighing the primary factor for inaccuracy or failure low battery, incorrect calibration, overload or operate on non-level surface. Please note that the above mentioned several points, with correct use and maintenance of your product.

• Do not display or displays a low battery symbol [LO] battery needs to be replaced;
• [EEEEE] overload, overload items should be removed immediately;
• [O-ld] due to error that scales the internal core part is damaged (for example, impact, dropping or overload), please try the calibration again, if the sensor is not severely damaged, then recalibrate after use.
• Display 88888, where they are not affected by vibration and stability of graphic work.

Matters needing attention

• Weighing of this product do not exceed the maximum amount of drive + 2%.
• Permanent damage of the product.
• The product is not exposed to very cold or very hot environments, this product is in a normal environment can work very well, before using it, to adapt product in a new environment for at least an hour.
• Before using it, power on the scale's internal components warm up scales weighing times, this makes weighing precision.
• Place the product in a clean environment, dust, moisture, vibration and air, or electromagnetic interference may have adverse effects on the stability and accuracy of the product. Gently, weighing objects when gently placed on the scale, so as to avoid inaccurate weighing or damage the scale's internal components.
• Because the product is a high precision products, so it is very careful handling to avoid vibration or falling.
• Horizontal use without wind.

• Tel: 0086-579-85184955
• Mobile phone: 13858915410
• Fax: 86579 85184955
• Add: Yiwu international trade city, Yiwu, Zhejiang, China G2-14955
• Company home page: http://www.ywscale14955.CN.Alibaba.com