12pcs of strength glue 502 red card bottle glue 5g

The 502 adhesive is mainly of e-cyanoacrylate, with adhesives, stabilizers, toughening agents,The polymerization retarderAnd so on, through the advanced production process synthesis of a single component instant solidificationadhesive.

Method of use

1. Clean the following surface first, remove the dust, oil, rust, etc., and then grind the metal first. For plastics such as PE, PP or PTEE, the surface should be activated first.

2. Open the front cover and tap the tip with your fingers, leaving no residual liquid, then cut the hole with scissors.

3. Put a small drop of the reagent on the followed surface, and immediately continue the reagent until hardening. The next area should not be too large, and the next layer thickness should not exceed 0.2mm.

4. Wipe the container after use and put the lid on. Store in a cool and dry place or refrigerate.

Matters needing attention

1. The vapors of this adhesive will stimulate mucous membranes and eyes.

2. Avoid contact with skin and eyes. If accidental, wash with plenty of water and send to doctor immediately.

3. Wash hands with soap, water, cleaning solution and pumice stone when touching them

Remove method

1. Use wet hot towels to stick to 502. After a dozen minutes, the 502 solidified will become soft and clear.

You can also add a drop of 502 to the 502, and the solidified 502 will soften, so you can remove it with a towel.

2. Put 502 in the original place to melt the original 502, and then wash it off quickly with water.

3. Use insulating oil. Put the insulating oil in the transformer on the table.