Connection procedures are as follows: (1) to start wire red wire tongs first on "being saved" above the Red cathode. (2) then plug the other end of the Red wire clamp in the "rescue" above the Red cathode. (3) wire clamp in black "rescued" the black negative battery. (4) wire clamp in black "rescue" the black negative battery. (5) start the "rescue" engine, and then start "rescued" engine. Anyone found to have rescued the car still does not start, check that the metal contact part is bad. When you finish after starting the engine, still need to be removed sequentially started to take fire, or you may cause a short circuit.

Removed line procedure is as follows:

(1) the first "rescued" black wires down. (2) then "salvage vehicle" black wires down. (3) and "rescue" lowered the Red wire. (4) the last "saved cart" under the Red wire with the exception of

"Considerations"

1, in strict accordance with the operation steps.

Marking of two 2, check the battery voltage, and make sure both battery voltage.

3, shut down all loads in the car, put it in neutral, pull the hand brake, start the engine. Ban on smoking in vehicles nearby.

4, if the car battery is frozen, no starting, as it may cause an explosion.

5, please ensure the correct polarity battery wiring.

6, when cars cannot come into contact with other vehicles.

7, the battery produces explosive gases! Wear eye protection when installing the cable.

8, if the acid in the battery accidentally leaked, when splashed down to the skin or eyes, immediately rinse with plenty of water, and then seek help from a doctor.

Environmental conditions:

Battery cables can work continuously and reliably under the following environmental conditions:

1, the air humidity should be less than 85%.

2, where without conductors, explosive dust, no corrosion of metal and damages insulation gases.

3, place of use without vibration and shock.