? ? ? Type RX-180, 100-240V wide voltage, 20W-45W power thermal Sol is not only widely used in electronic industry, but also plays a lot of roles in general home repair and maintenance, and is one of the necessary tools, especially suitable for homemade small crafts. ? Small power 20W-45W hot melt glue gun, metal glue outlet, small and light, used for bonding, fixing, waterproof and shockproof, easy to use. The working voltage is AC100-240V, which can be directly inserted into 220V mains. It is more convenient to carry without using transformers. High speed, fatigue resistance, high insulation, high temperature resistance, corrosion resistance, can be used for handicrafts, cloth ornament, artificial flowers, models, long wool toys, stuffed toys, PC boards, electronic parts, leather products, ceramic products, ceramic tile, plastic, PVC, acrylic, ABS, metal, aluminum sheet, food packaging, woodworking wood, furniture, paper, cardboard, paper box, Stone. ? ? 1. High-performance heating element is adopted, melt glue is fast and the thickness is moderate; 2. Smooth tape import the trigger, allowing you to easily control the amount of melt glue; 3. All iron materials, ceramics, plastics, and acrylic products can be used; ? Usage 1. Support the bracket before use (the angle of the bracket can be adjusted) 2. Turn on the power supply and insert the glue stick into the rear of the glue gun 3. Press your finger several times until glue stick is fixed in the glue gun nozzle 4. Use it after glue gun fever for about 3 minutes 5. Press and hold your hand until the glue flows out of the nozzle 6. Cut off the power after use, no need to clean the nozzle, no need to take out the adhesive strip ? It is suggested that the diameter of the Sol strip used is 7.5~8.0mm. If the adhesive strip of other sizes is used, it may cause backflow or block glue gun, so as to avoid using the hot-melt adhesive strip stored for a long time. Polyamide rubber strip has strong hygroscopicity and should be sealed and preserved. Sol gun when working, the temperature of the melting adhesive and nozzle will be as high as over 100 degrees, which is very hot. Do not touch the human body directly. Due to the thermal expansion of the adhesive, a small amount of adhesive still leaks out of the nozzle for a period of time after the stop of work, which is a normal phenomenon. ? A. Please do not inject liquid or paste adhesive into the gun, which may cause the risk of burning. B. Hot glue may splash on the skin. When this happens, rinse the skin with cold water for a few minutes before slowly removing the hot glue. C. Fingers should not touch nozzle or melted adhesive without protection.