Applicable Scope:

Metal, rubber, plastic, electronic components, jewelry, electrical components, etc.

Usage Method:

1. First, clean the surface, removing any dust, oil, rust, and other contaminants. For metal surfaces, it is best to first grind the surface rough. For PE, PP, or PTEE plastics, it is necessary to first activate the surface.

2. Open the front cover and gently tap the tip with your fingers to ensure no residual liquid remains, then cut out the holes with scissors.

3. Drop a small amount of adhesive on the surface to be joined, immediately proceed with the joining, and maintain until the adhesive is fully hardened. The area of the joint should not be too large, and the thickness of the joint layer should not exceed 0.2mm.

4. After use, wipe the container, cover the lid, and store it in a cool and dry place or refrigerate.

Notes:

1. The vapor of this adhesive will irritate the mucous membranes and eyes.

2. Avoid contact with skin and eyes. If contact occurs by accident, immediately wash with large amounts of water and seek medical attention. To cleanse the eyes, use a weak solution of sodium bicarbonate.

3. When touching the hands, it can be washed with soap, water, detergent, and pumice.

Shelf Life: 12 Months (20°C)