Battery Closed Battery Line Fire Line 2000A Antifreeze Automotive Emergency Battery Clamp Battery Line

SAILHOPE HARDWARE TOOLS 14yr.

Contacts:Lu Minghui Chat

Mobile:86-13819957205

E-mail:waycsu880603@163.com

Click to Contact Yiwugo official customer service for International sourcing.

Yiwugo official customer service X

Whatsapp:

Email： yiwubuy@yiwugo.com

Description
Reviews(/5)

Lighter line knowledge:
Normal 1.6 displacement of the car, the fire line must meet more than 8 square meters of the product can be a normal success, if the 2.0 displacement of the car, it must be more than 10 square fire line can be a successful ignition, 3.0 The above must be 12 square feet of the line! And this product is 35 square (thick plus thick battery line) of the high-end battery line, almost all types of cars on the market.Ensure that the current is usually used to increase the shelf life of the product

2000A heavy clip, bold 35 square feet.

2 meters price of 36 yuan 20PCS/CTN each set of weight 1.7KG

2.5 meters price 40 yuan 20PCS/CTN each set of weight 2.0 KG

3 meters price 45 yuan 20PCS/CTN each set of weight 2.3KG

Oxford cloth transparent bag, can effectively protect the product. & Nbsp;

Strong blessing ability, need a lot of effort to open the clip, after clamping will not easily fall off.

Antifreeze resistance, insulationHigh-end battery line, to extend product life

When your car because no electricity can not hit the car do not worry, from the roadside to make a taxi over two easy to get a folder.

The connection procedure is as follows:
(1) first start the line of the red wire clamp in the red battery on the poles above the pole.
(2) and then the other end of the red wire clamp in the ambulance of the red battery cathode.
(3) the black wire clamp in the rescue of the black negative battery.
(4) Then put the black wire pliers on the black negative battery of the ambulance.
(5) first start the ambulance engine, and then start the ambulance engine. If you can not start the rescue, please check whether the metal contact part of the poor contact. When the start of the engine after the completion of the need to be removed in order to start with FireWire, otherwise it may cause a short circuit.

The procedure for removing the lines is as follows:
(1) first remove the black wire by the rescue car.
(2) Then remove the black wire of the rescue vehicle.
(3) Then remove the red wire of the ambulance.
(4) Finally, the red wire to be rescued by car.

& Nbsp; [Note]
1, in strict accordance with the operation steps.
2. Check the voltage of the two batteries to ensure that the voltage of the two batteries is the same.
3, turn off all the load on the car, hanging air stalls, pull the hand brake, start the engine. Do not smoke near the vehicle.
4, if the car battery has been frozen, prohibited to start, otherwise it may lead to explosion.
5, please ensure that the polarity of the battery wiring is correct.
6, the operation, the car can not contact with other vehicles.
7, the battery will produce explosive gas! Wear protective goggles when installing cables.
8, if the battery in the acidic substances inadvertently leak, splashed into the skin or eyes, please immediately rinse with plenty of water, and then to the doctor for help.

【Environmental conditions】:
The battery line can operate continuously and reliably under the following environmental conditions:
1, the relative humidity of air should be less than 85%.
2, the use of location without wires, explosion dust, no corrosion of metal and damage the insulation of the gas.

3, the use of location without vibration and shock.

Update time：20210309162652