Oushangriyongjiaju Baihuohuo

Note: The genuine Springcome brand products we sell are electroplated.

The instructions are printed on the box of the machine!

We guarantee that it is genuine, and if it is not, we will pay you ten times the amount!!

Micro sewing machine correct usage method

1. Hold the machine: Use the four fingers of your right hand to support the base, and naturally place your thumb on the top of the body cover, holding the entire machine steadily.

2. Thread Tying: Gently pull the thread from the spool. Pass it through the guide line diagram A, and then lead it into the clamping adjustment piece.

B. Then pass through the guide coil. C. Temporary place the thread head that has been guided beside the machine needle, and then pass the threader through the machine needle hole from the front of the machine needle (towards the body joint), and then introduce the thread head into the small hole of the threader, and then pull out the threader to press the head thread about 2-3 cm on the pressing board and then use it as needed.

3. Release the fabric: Lift the press plate with the index finger of your right hand, place the prepared fabric (thickness no more than 0.8 mm) flatly under the press plate, and gently replace the press plate to press the fabric;

4. Sewing operation: Hold the fabric with your left hand, and press the upper cover top with your right thumb gently and quickly to the bottom. After pressing, press again with your thumb, and repeat this process. The feeding mechanism will automatically move the sewn item to the left. As the machine is held with the right hand, the left hand holding the fabric should move the sewn item to the left gently in sync with the sewing rhythm until the sewing is complete.

5. End: Sewing is complete. Cut the thread with scissors and gently lift the presser foot to remove the fabric. From the reverse side of the fabric to be sewn, pull out the last section of thread, thread it through the adjacent loop and tighten, making a knot, and the stitching will be secure.Do not pull the thread ends off with a hard tug at the end of sewing to avoid damaging the sewing machine needle or stitches.

6. This function can automatically advance the fabric and adjust the tension between the stitches, but it is very necessary to pay attention to the following points:

A. The pin is too tight, adjust the pressure nut slightly counterclockwise.

B. The pins are too loose, adjust the pressure nut slightly clockwise.

As shown, the correct tension of the stitches is achieved. If you need larger stitches, you can pull the fabric slightly faster with your left hand. If you need tighter stitches, you can pull the fabric slightly slower with your left hand;

7. Change the thread ball; if you need to change to a larger thread ball, you can connect the spare extending rod to the thread ball shaft, insert the larger thread ball into it. Place the spare plastic cap at the end of the rod to fix the larger thread ball, and then re-thread the needle, adjust the tightness of the thread after sewing; using 50#-90# cotton thread or synthetic thread works very well;

8. Change the needle: Loosen the fixed screw, remove the broken needle. Install the new needle, making sure the flat side of the needle is aligned with the fixed screw, and do not install it backwards. The needle type is DHK-14.