This is the real carbon fiber reflective stick, reflective effect is very good, the market copy, I hope you carefully identify customers, do not take cheap products to compare. There is no comparability. Welcome to take samples to store for quality comparison.

[name] : anti-collision sticker

[process] : crystal glue car stickers
[style] : as shown in the figure below
[specification] : one set (four doors)
[size] : 168MM*22MM
[material] : carbon fiber + reflective PC
[color] : as shown in the figure

Instructions:
First of all, the shop is composed of three parts:

The first layer is a transparent transfer film with moderate viscosity (the sticker needs to be removed after affixing).

The second layer is the sticker, and the third layer is the base paper, which is generally yellow (the materials we use are mainly westpac a-level reflective film and KK special film for sticker in Taiwan).
2. Since the stickers are rolled up when packaging and delivering goods, bubbles sometimes appear on the yellow background paper and transfer film, which is a normal phenomenon and will not affect the adhesive effect of the stickers.

Put it on a flat surface and scrape it with a scraper or credit card before pasting it on.
Three, please note: the correct way to open the sticker is to expose the paper, rather than directly tear the transfer film.

The bottom paper must be opened slowly, the speed of the car sticker does not stick to the yellow paper is appropriate.
4. Determine the position to be pasted first, and then open the pasting after cleaning:
1. Dry paste method (applicable for adhesive tape within 30CM) : compare the adhesive tape Angle with the position to be pasted, hold down the two angles of the transfer film on the left side and scrape while pasting to ensure that there is no bubble inside the adhesive tape.

After the whole post, scrape the flat sticker with a scraper or a credit card. You should pay attention not to use too much force, otherwise the transfer film will affect the effect of the sticker.
2. Wet pasting method (applicable for large vehicle pasting above 30CM) : apply clean water to the position to be pasted and to the vehicle with removed base paper to evenly spray water.

After adjusting the Angle, gently scrape the water from one side to the other.

Five, after the paste, be careful to remove the transfer film, winter can be blown with a hot air gun (or hair dryer), to ensure that the paste is completely firmly stuck to the car.

Do not wash the car as much as possible after the completion, generally about three days is appropriate.