101 industrial tag gun: complete set with 3 steel pins

Needles: the length of the needle is 3.5 cm

Match: set set with 5000 hairspray needles Suitable for aliexpress amazon sales.

Tagging Gun
The tag gun
Includes 2000 Fasteners and 6 Needles
Including 2000 fasteners and 6 needles

The Tag Fasteners Installation
Installation of fasteners
Grip the gun handle
Step 1: hold the gun tightly
Insert either end of the tag pin connecting bar (T letter port) into the hole at top of the gun, push the pin into the slot as far as it will go on
Step 2: insert either end of the tag pin connector (T port) into the hole at the top of the gun and push the pin into the slot as far as possible.
Release the handle,finish and begin use
Step 3: release the handle, complete and start using
Needle Installation
Binding needle mounting
Set the white switch to 3 o'clock
Step 1: set the white switch to 3 o 'clock
Keep the needle slot and gun slot on the same horizontal line and insert
Step 2: keep the needle slot and gun slot at the same level and insert
Set the white switch to 9 o'clock finish and begin to use
Step 3: set the white switch to end and start at 9 o 'clock
Attantion:
Note:
When not use,protect the needle by the covering cap.
1. Protect the needle with a cap when not in use.
Before taking out the tag pin,please grip the gun handle firstly,then take it out.Otherwise,it may damage the fittings in the gun
2. Before removing the label pin, please grasp the gun handle first and then remove it, otherwise it will damage the gun accessories