The whole system is equipped with 3 steel needle heads

Product name: color hong  

Model: 101

Needle size: 2MM needle thread   

             The whole length is 3.5 cm   The length of the leaking gun is 2.3 cm

              Sharp tip Effective use

Scope of application: matched with 50 pins and 56 pins per piece

Tagging Gun
The tag gun

The Tag Fasteners Installation
Installation of fasteners
Grip the gun handle
Step 1: hold the gun
Insert either end of the tag pin bar (T letter port) into the hole at top of the gun, push the pin into the slot as far as it will go on
Step 2: insert either end of the tag pin connector (T letter port) into the hole in the top of the gun and push the pin into the slot as far as possible.
Release the handle,finish and begin use
Step 3: release the handle, finish and start using
Needle Installation
Install with baling pin
Set the white switch to 3 o'clock
Step 1: set the white switch to 3 o 'clock
Keep the needle slot and gun slot on the same horizontal line and insert
Step 2: keep the pin groove and gun groove at the same level and insert
Set the white switch to 9 o'clock finish and begin to use
Step 3: set the white switch to end and start at 9 o 'clock
Attantion:
Note:
1 When not use,protect the needle by the covering cap.
1. When not in use, use the cap to protect the pin.
2 Before taking out the tag pin,please grip the gun handle firstly,then take it out.Otherwise,it may damage the fittings in the gun
2. Before taking out the tag pin, please grab the handle of the gun and then take it out, otherwise the accessories in the gun will be damaged