This product raw material all USES Shanghai stainless steel factory production special stainless steel, before processing all passes the special craft processing, compared with the same brand material has the better oil resistance, the acid, the alkali, the hydrochloric acid solution performance!
In the process of production, the surface is processed by multiple polishing processes, and the surface becomes wire-drawing.
Spray system: the 56 water outlet holes in the spray area are evenly distributed, and the water is evenly distributed in the process of spray, which is more comprehensive to the body and better to the effect of spray!
Eyewash system: the eyewash nozzle adopts built-in double-layer PP filter net (never rusting), which can filter sundries in the water and make the water source cleaner. In addition, the principle of slow pressure is used to make the water jet into foam, which is more gentle and won't cause secondary damage to the eye film and the inner nerve of the eye due to excessive water flow in the process of use. Compared with the traditional eye washing machine, eye washing effect is better and safer!
This product is suitable for use indoors or in areas where the weather temperature is higher than 0℃.
Places of use: widely used in nuclear energy, power stations, pharmaceutical, medical, chemical, petrochemical, electronics, metallurgy, smelting, printing, printing and dyeing, education and research institutions
Installation instructions: 1. It shall be installed directly on the ground of the work site, and the distance shall not exceed 15 meters near the dangerous work area. It takes less than 10 seconds for the straight line to reach the eye washer. When the chemicals splash into the eyes, face, neck and body of the staff, the eye washer should be used in time for a big rinse to reduce the damage and gain precious time for medical rescue
2. No non-explosion-proof electrical switch is allowed within the 2-meter radius of the eye washer
3. Do not stack any obstacles within the 2-meter radius of the eye washer.
4. It is not possible to install the eye washer beyond the layer
5, must be connected to drinking tap water.
6. According to the installation hole position of the bottom seat of the eye washer, drill 3 holes with a diameter of 10mm on the ground where the eye washer needs to be installed and fix them with stainless steel expansion screws.
7. According to the assembly part drawing of the eye washer, install the whole eye washer part one by one. The water pipe connection must use the sealing raw material belt.
8, during the installation process, spray head, eyewash elbow and water outlet should be 90 degrees each other.
Special note: according to the American ANSI z358-1 2004 eye wash standard, special note: the spray system and eye wash system are not on the same plane, the minimum Angle of the two is 45 degrees.
Instructions: when using, push the valve gently with the hand, and the clean water will be ejected automatically; After use, close the eye wash hand push valve and spray hand pull valve, and replace the dust cover
All products of our company can be equipped with luminous signs and lighting tools, which are more convenient to use at night.