LED high-power highlighter dp-737a

Product parameters
The Product Specifications                              

Material: ABS environmental protection raw material
Product color: red
Number of lamp holders: 1
Power supply: built-in high capacity battery
Battery capacity: 5000mAh
Charging time: 15 hours
Available time: 30 hours
Product size: 120x164x215mm

Light source configuration [power]: 3W
Rated voltage: 90~~240VAC 50/60hz
Rated current: DC400mA 2.2w
Color temperature: white light
Package size: 215x127x167mm
Outer box size: 66x44.4x35.5cm
Gross weight: 25.4kg
Bar code: 6939020440371

Directions for use
Instructions

· when charging, insert one end of the two holes of the power cord of the mine lamp into the AC socket of the mine lamp completely, and directly insert one end of the power cord with plug into the AC90 ~ 240V power socket. The red charging indicator light is on, indicating that the mine lamp is in charging state.
· when the charging timing time is up and the green indicator light is on, it indicates that the mine lamp battery is fully charged. Please pull out the power cord at this time, so as not to damage the battery after charging for too long; The charging timing time is about 15 hours.
· press the switch to control the low light and strong light and shutdown state of the mine lamp.
· when the switch is pressed to low light level, it can be continuously used for 30 hours with full charge. Press the switch to the strong light; Fully charged for 15 hours of continuous use.
· in the use process, when the LED lamp turns from bright to dim, the battery tends to be in the state of full discharge. In order to protect the battery, the battery should stop using and must be charged in time (it should not be charged when the LED lamp is completely out of light, when the battery is vulnerable to damage and failure).
· the mine lamp should be used for charging frequently. Please do not use it for a long time. If not frequently used, please recharge for about 10 hours every three months after storage, otherwise the battery life will be reduced.

Maintenance instructions
Maintenance

· the charging power supply and socket shall be installed in accordance with safety specifications.
· do not use the product when charging to avoid burning the LED lamp or internal charging parts of the power supply.
· do not direct the mine lamp to the eye, so as not to affect the vision.
· do not allow the product to get wet or wet.
· keep away from inflammable and explosive items when charging each time. The maximum charging time shall not exceed 24 hours. (charging is recommended during the day).