Solar - Mobile Induction Intruder Alarm and Animal Repeller Solar - Mobile Induction drive dynamometer can illustrate the evil invasion and animals

 This alarm scrubber is designed to be used only once.

Its weatherproof design allows the product to be used in almost any weather for years.Solar energy is used to charge the battery, so the product can be operated continuously.

 (move the switch to the \"NO\" position: ultrasonic LED flash drive animals) infrared sensing head moving object detection and trigger ultrasonic sound, ultrasonic, which humans cannot hear, but as a dog, cat, deer, raccoons, mice, skunks, squirrels, wild boar and some outdoor animals such as reindeer, will be able to hear this kind of ultrasound to look at and LED flash, and is driven.

(move the switch to position \"ALARM\" : ultrasonic + high-decibel ALARM +LED flash function) the infrared sensor head can detect moving objects and simultaneously trigger 65-120 db ALARM sound, ultrasonic and bright light, to prevent the bad guys and large dangerous animals to enter and be driven away, to protect your personal safety.

This solar powered alarm scrubber keeps bad guys and animals away from you in a safe and humane way.

Warning: before digging holes for installation, check underground utilities such as cables, wires, etc. If not checked, it may cause personal injury, property damage or even death.

 Assembly and installation

      1. Fully open the package and confirm the existence of the parts

1. When the switch is turned on, the infrared sensor head will remain in operation. The product USES 4 2/3aa rechargeable batteries.
2.  

 When the switch is turned on, the red light goes on and the ultrasonic signal will work for 15 seconds. During this time, a sound wave 2.5 seconds long will be produced. At the same time, the white light will flash strongly. After 15 seconds, the product will go into standby mode.

  Now the product can be installed. The installation site should receive sufficient sunlight to allow the battery to be fully charged. Make sure that the area to be protected is within the range of the expeller's effectiveness.

  For effect, keep the head of the retractor 9 to 10 inches above the ground.

 Be careful not to crush or damage the scrubber when installing on hard ground. After finishing the floor, install the floor bracket to avoid damage to the product.

 When the infrared sensor detects the signal, the red light will light up. The sound is ultrasonic, and the white light will flash for 15 seconds. After that, the expeller will return to standby mode.

When the device is working and the external red sensor head detects the signal again, the scrubber will continue to run for 15 seconds.

 Specifications Specifications:

 1.Unit Dimensions       5-1/2\" W x 3 x 14 1/3-1/2 \"D\" h

 2. The Unit Weight:  The product weight            445 g

 3. Power Supply                  4 * 2/3 aa Ni - MH rechargeable batteries.

 4. The Power Consumption:               Power consumption Working = 15 ma standby 10 ua or less

 5. Ultrasonic Frequency:                Ultrasonic frequency 15-75 KHZ

 6. The alarm sound 120 db:            Alarm volume 65-120 decibels              

 7. Coverage Area: 30 feet@ 1100=2,425 square feet

 CAUTION: pay attention to

 Keep the animal remover running to achieve results.

 Do not immerse the expeller in water

Do not block the infrared sensor head

 Use a damp towel and clean water with a small amount of soap. Do not clean with irritating chemicals or abrasive materials that may damage the scrubber