1. Height adjustment: put the screen frame flat on the table. According to the height of the substrate or printing requirements, turn the upper and lower adjusting handle to reach the appropriate height.

2. Fine adjustment left and right: release the handle on both sides of the nose, and turn the handle to fine adjustment left and right according to the need; When you're done, screw down both handles.

3. Front and rear fine adjustment: First, loosen the four red knobs on the chuck slightly. Use the fine adjustment knobs on both sides of the front of the chuck to loosen and make fine adjustment back and forth as needed.

4. The screen frame chuck is 280 mm in width and 80 mm in height, which can be used for all kinds of screen frames with thickness below 50 mm. The screen frame chuck is installed with three fixed handle of screen frame and equipped with special screen frame bar.

5. Lifting the screen frame and adjusting the static balance through the gravity balance plate (the machine is equipped with two gravity balance plates, which can be installed one or two times according to the balance needs). The gravity balance plate can move forward and backward 100mm as needed; If the weight of the screen frame is too large, the hole on the top of the balance frame can be added with gravity.
The lifting Angle of the screen frame can be adjusted by the screws in the lower part of the balance frame. The lifting height of the screen frame can be adjusted according to the need.

6, the main body of the machine adopts advanced electrostatic spraying metal surface treatment, acid and alkali resistance, corrosion resistance, clean resistance, no rust, can be used for a long time; Some parts are made of stainless steel.

7. Free fumigation wooden box packing according to European and American standards. All kinds of metal parts in the box are packed separately or placed separately to ensure that all kinds of metal parts are not directly touched;

8. Applicable screen frame:
The machine is suitable for mesh frames made of various materials with an inner diameter of 330 mm, a length of 430 mm and a thickness of 50 mm.
The recommended printing area is 280 mm wide and up to 380 mm long.