Hand press sealing machine type 300 plastic bag Aluminum foil Bag vacuum bag plastic shell

 Compared with other sealing machines, the manual sealing machine is not only small in size, easy to carry and relatively simple to use.The manual sealing machine does not need a power switch. Insert the AC power cord into the socket according to the thickness of the material to be sealed, adjust the heating time. Put the plastic bag on the sealing surface, press the handle and the heating time will be automatically controlled by the circuit.

When the indicator light of sealing machine goes out, the power will be cut off automatically. After 1-2 seconds, release the handle and seal.Too short a heating time may result in poor sealing. The sealing machine knob can be rotated clockwise and extendedTime.

 If there is a seal when the seal broken it up, so is usually caused by heating time is too long. At this time onlyThe knob must be turned counterclockwise to shorten the heating time. If the plastic bag is stuck to the rubber pressing plate, it should be cooledIt is necessary to extend the cooling time after the indicator light goes out. Please release the handle a little later.

 After the heating time has been adjusted, it should remain unchanged when used. There is no need to adjust the unit in continuous useThe AC power cord can be plugged into the power socket at all times. It can type without power consumption when not sealedWhen typing is required, the rubber press is used in reverse.

 If sealing machine electric below the lining damage, it will cause short circuit and damage electric tropical. So every timeWhen changing the electric belt, check the intact condition of the gasket. Replace it with a new one if damaged. When it is necessary to change the electric belt, please use the same specification as the original one after a long time of use, please check it like a rubber sheet.