e7000 high strength glue 110ml diy toy jewelry point drill leather acrylic glue non-corrosive glue

E7000 Corrosion-Free Drilling Needle Adhesive for Special Purposes

Specification: 110ml

Usage Method and Precautions

1. Read the instructions before use. Only use in an environment with good ventilation. The surface to be bonded should be clean, dry, and free of dust. Before use, rough the surface to ensure the bonding strength, and it can be used between 10℃ to 32℃. The effect is better between 21℃ to 29℃. This adhesive can withstand temperatures between -40℃ to 66℃ after curing. Before formal use, perform a small-area test.

Apply a thin layer of the adhesive directly onto the surface to be bonded, press firmly, and wait for it to start thickening after about two minutes. It will start to solidify after 10 minutes. For higher strength, allow the bonded parts to dry for 24-72 hours. The curing time will be longer when the temperature is low and shorter when it is high. You can speed up the curing process by using a hand-held hair dryer, but it should be set to the low temperature setting and not directly aimed at the adhesive.

3 You can use acetone or turpentine to remove unset glue. Once the material has cured, it can be removed with a tool or scraped off.

4 If this universal adhesive is used to bond fabric, do not dry clean the fabric.

Model 5: This universal adhesive is not recommended for bonding foam polystyrene, polystyrene, polyethylene, and polypropylene plastics.

Storage Method: Store at temperatures between 10 and 27 degrees Celsius. Freeze/Thaw: Allow the product to reach room temperature before opening the lid.

Same model adhesive recommended (click the picture to enter the details)