The pattern of the hole-punched rings is too numerous to list them all, so please consult us for any specific designs. Each pattern has a different price, and the price will be discussed separately.

The color difference between the rod and support, the head, and the ring is normal. The following pictures were taken under specific lighting conditions, and the color difference appears to be reduced. The actual color difference may appear larger due to different lighting environments. Please refer to the actual product. Those who care about color difference may consider the color to be completely different. Those who require perfection should be cautious when purchasing. Xinjiang, Tibet, and overseas areas are not included in the free shipping range. Please contact the customer service for specific information.
The price per meter is based on the number of meters needed, and you should purchase the same number of pieces. Default includes the head, slide ring, support, screws, expansion tube, and connectors.
For example, if you take a pole that is 1 meter long, it is 0.86 meters plus two decorations heads that are 0.14 meters, which equals 1 meter. [Self-purchased orders will not be shipped]. Orders for poles longer than 2 meters (not including the heads) will be cut and shipped due to [courier reasons].
Curtain rod installation: First, determine the installation points of the curtain rod, including the height and width, and then proceed with the installation of the curtain rod.
1. Determine the width of the curtain rod
Step 2: Determine the height of the curtain rod
1) The installation height of the Roman rod: at the middle position above the ceiling to the window frame.
2) The installation height of the curtain track: at the top of the curtain box, or side-mounted in any part of the curtain box.
Three, curtain rod installation
1) If the wall is made of wood, you can simply screw the installation tracks directly into the determined positions on the wood.
2）If the wall is made of cement, you need to drill holes at the determined positions, then knock the special nylon expansion tubes into the holes, and then screw the screws into the special plastic expansion tubes and tighten them. (Please refer to the following for the items needed for installing the Roman rod on the cement wall:
Hammer drill and matching Φ6mm drill bits, steel tape measure, pencil, screwdriver, Φ6mm plastic expansion tube, Φ4×40mm self-tapping screws. The drill bit is generally long, greater than 80mm is sufficient.
1) Prepare
Check the compatibility of the Roman rod and its decorative head, supports, and hooks, measure the length of the Roman rod, and the width of the window.
2）Underline
Use the installed bracket as the standard to mark the line, and draw the bracket positioning line and the hole position line. (For three brackets, the center bracket is located in the center of the window or wall, and the ends must be equal distance).
The supports at both ends should be approximately 15-20cm away from the wall or 5-10cm away from the end of the Roman rod.
3) Drilling holes
Drilling depth 4-4.5cm, the hole cannot be run-out or tilted. Note: Stay away from electrical wires and pipes. After drilling, hammer the plastic expansion tube into the hole.
4) Installation Pole
The support is tightened with self-tapping screws; the hoist ring is inserted into the rod, and the hoist ring is divided into two, with 1-2 hoist rings left at each end; press the Roman rod into the opening support, adjust to make the distance between the two ends of the decorative head away from the wall consistent.
Hang curtains
Hang the curtain hooks, and insert the other end of the hook into the hole of the hanging ring; open and close the curtain to the left and right, check if the sliding is flexible and whether the two curtains are the same height. If not, adjust slightly.