wallpaper foaming: wallpaper foaming is a common problem, mainly due to uneven gluing when pasting wallpaper, which leads to excessive shrinkage force on the surface of the wallpaper and excessive moisture separation from the base layer, resulting in some built-in bubbles. In fact, the solution is very simple. As long as you pierce the bubbles on the surface of the wallpaper with a general sewing needle, release the gas, and then use syringe to extract a proper amount of adhesive into the just pinhole, finally, re-flatten the wallpaper and dry it.

Moldy wallpaper: moldy wallpaper usually occurs in rainy season and humid weather, mainly because the wall moisture is too high. Wallpaper that is not too serious due to mildew solution as follows: wipe with a white towel and a proper amount of clean water, otherwise wipe with soap. The best way is to go to the wallpaper shop to buy a special ant-mold agent.

Wallpaper curling: wallpaper Curling may be basic treatment not clean, adhesive adhesion is too low or package positive angle the wallpaper edge is less than 2mm and other reasons. Solution: apply the wallpaper glue powder to the curling area, smooth the warped area, use hair Dryer blow for about 10 seconds, use again hand Press solid, until it sticks firmly, blow it to dry with a hair dryer.

Scrubbing of wallpaper: use wet cloth or dry cloth to scrub places with dirt; Do not use some colored raw materials to pollute wallpaper, otherwise it will be difficult to remove; wiping wallpaper should start at some corners of the wall or hidden places behind the door to avoid appearing. Adverse reaction the wallpaper is damaged.