tesla modely model3 s modification special carbon fiber welcome pedal rear guard board inner door sill strip

Product Name: Threshold Strip

Applicable vehicle models: Tesla Model Y, Model 3, Model S

Product material: Carbon fiber

Product Specification: 4 pieces of built-in threshold strips and 4 pieces of external threshold strips.

Installation Method: 3M Adhesive Tape Attachment

Instruction Manual

1. Simulated Installation
Compare and adjust the product to the exact position on the vehicle where it needs to be installed.
Surface Treatment
（1）清洁" - "Clean
Clean the body of the car with a towel dampened with alcohol or water at the areas where installation is required.
（2）注意事项
Before installation, the body must be kept dry and free of dust, oil, wax, and at temperatures below 10 degrees Celsius, ensure that the 3M adhesive on the body and the product is heated.
The use of thickening agents
Wipe the area where you want to apply the adhesive with a cotton swab or tissue (a small amount) to prepare the surface of the vehicle.
（4）Installation
First, tear a corner of the 3M protective film on the back of the product, leaving the film outside to ensure accurate positioning of the product. Then, slowly peel the film and press it down to attach it.
Safe period
After the product installation is completed, you cannot contact water, oil, or large amounts of dust at the adhesive position within 48 hours.。

Note: Please compare before installation. Refusal to return or exchange if the red film on the back is removed.