prepare:

1. Select the appropriate saw blade according to the design requirements of the equipment.

The equipment shall be equipped with safety protection devices, such as protective cover, power-off brake, overload protection, etc.

We have professional operators to install and use, wear Labor clothing, wear protective eyewear, earmuffs, etc.

Workers should not wear gloves, long hair should be placed within work cap, and pay attention to ties and cuffs to prevent danger.

Stay away from fire and humid environment.

     Installation and commissioning:

 1. The equipment is in good condition, the spindle has no deformation, no diameter jump, solid installation and fixation, no vibration, etc.

Check whether the saw blade is damaged, whether the tooth type is complete, whether the saw plate is smooth and clean, and whether there are other abnormal phenomena to ensure safe use.

3. When assembling, make sure that the direction of the saw blade arrow is consistent with the rotation direction of the equipment spindle.

When installing the saw blade, the axis should be kept. The Chuck and flange should be clean. The inner diameter of the flange should be the same as the inner diameter of the saw blade to ensure that the flange and saw blade are closely combined. Install the locating pin and tighten the nut. The size of the flange plate should be appropriate, and the outer diameter should not be less than the diameter of the saw blade.1/3.

Before the equipment is started, if there is a single person operating the equipment to ensure safety, tap and idle, check whether the equipment is turning correctly, whether there is vibration or not, and idle for a few minutes after the saw blade is installed, without slipping, work normally after swinging or beating.

Precautions during work:

1. When working, the workpiece should be fixed, and the positioning of the profile should conform to the direction of the knife, so as not to cause abnormal cutting. Do not apply side pressure or curve cutting, and the feed should be stable to avoid the impact of the blade to contact the workpiece, as a result, the saw blade is damaged, or the workpiece flies out, and an accident occurs.

When you are working, if you find abnormal sound and vibration, rough cutting surface, or peculiar smell, you must immediately terminate the operation and check in time to eliminate the fault so as to avoid accidents.

When starting and stopping cutting, do not feed too fast to avoid causing broken teeth and damage.

⒋ if cutting aluminum alloy or other metals, use a dedicated cooling lubricating fluid to prevent the saw blade from overheating, causing paste teeth, and other damage, affecting the cutting quality.

The chip removal tank and slag suction device of the equipment ensure smooth flow to prevent slag accumulation into blocks and affect production and safety.

During dry cutting, please do not cut continuously for a long time, so as not to affect the service life and cutting effect of the saw blade; When cutting wet chips, water should be added to cut, so as to prevent leakage.

Preservation and maintenance:

1. If the saw blade is not used immediately, it should be laid flat or hung by using the inner hole. Other items or feet cannot be stacked on the flat saw blade, and attention should be paid to moisture-proof and rust-proof.

When the saw blade is no longer sharp and the cutting surface is rough, it must be reground in time. Grinding cannot change the original angle and destroy the dynamic balance.

The inner diameter correction and positioning hole processing of the saw blade must be carried out by the factory. If the processing is not good, it will affect the use effect of the product and may be dangerous. In principle, the reaming cannot exceed the original aperture.20mm to avoid affecting the balance of stress.

Suitable for soft weeds, fish grass, etc. Applicable occasions: Daily weeding in parks, orchards, farms, harvesting fish grass, etc.
Features: large cutting diameter, fast speed, sharp cutting edge, high efficiency, economical and affordable

Most lawn mowers in the market are suitable
Inner diameter: 25.4mm length 255mm