Search history
Clear allSearch by image
XDrag and drop an image here or upload an image
Max 5MB per image
UploadSign In | Join
X Email Mobile
| zyx-q520 red ordinary clip | CN¥ 155.0 |
| zyx-q520 red ordinary enhanced version | CN¥ 175.0 |
| zyx-q520 red smart clip | CN¥ 166.0 |
| zyx-q520 red enhanced smart clip | CN¥ 198.0 |
Use tips! (All charging treasures can be referred to)
The product has just been received. First, turn on the flashlight to discharge it, then charge the product for more than 4 hours, and finally start the car, as the product contains virtual electricity. This procedure can extend the service life of the product!
Tips for daily maintenance:1: The battery has a shelf life. Whether you use it or not, it is recommended to charge and discharge the battery once every 2–3 months.
2. When it is not used for a long time! Please keep 3 grids of power supply or more than 50% of power!
(t_XXXXXXXX) Tips: Remember to charge the battery every 2–3 months when you aren’t using it. If the power supply is low or the storage of virtual power affects the battery, proper maintenance will help extend its lifespan~~
Before use, there is a small prompt[t_XXXXXXXX] The car cannot be started due to continuous ignition, or the key cannot be turned, and the positive and negative poles...
[t_XXXXXXXX] cannot be reversed after every 30 seconds of starting. The two clips must not be short-circuited.
[3] Remove the clip within 30 seconds after successfully starting the car.
Violating the above three procedures may cause the [fuse box] of the clip to burn out. Please pay attention to the operation method.
Feature:
Stable voltage, current, and balance charging function.
Class A+ cell, safe and explosion protective.
Upgrade cell 4 and start strongly.
1000A Starting current.
2000A Peak current
2,0000 mAh Large Capacity.
A diesel 3.0L and a gasoline 5.0L vehicle are acceptable.
Reverse connection protection.
2 USB charging ports.
Full power can be activated 40 times.
Temperature limit: -20 ~ 60°C.
Intelligent Protection System.
5V-2.4A
5V-2.4A*2; 12V Jump Start
Night emergency, Rescue lighting:
1. Built-in glare lighting system.
2. Long-press the middle button for 3 seconds, then press it again in burst mode.
3. After turning on the flashlight, press the switch again to activate the flash function; this switch operates in distress mode.
Note:
When using the product, you should first turn on the flashlight to discharge it, and then charge the product for more than 4 hours before starting the car, as the product contains virtual electricity, which can extend its service life.









Update time:
TOP