Solar-powered motion-activated animal repellent

Thank you for choosing this animal repellent. Please read and understand these instructions, and save this manual for future reference. This is a permanent service, so you can install it once and let it work! It is weatherproof, allowing it to work all year round, and it works almost in all weather conditions. It charges its batteries using solar energy, so it is always working. Passive infrared sensors (PIR) detect movement and trigger ultrasonic speakers to emit sound that people cannot hear, but will drive away common outdoor pests such as dogs, cats, deer, raccoons, mice, skunks, squirrels, and more. This solar-powered animal repeller is a safe and humane way to keep unwanted animals away!

Warning! Always inspect underground facilities, cables, or.
Before digging or installing wires! A failure in the check may lead to
Personal injury, property damage, or even death.

Assembly and Installation:
1. Open the device packaging completely and confirm the presence of all parts.
2. Connect the reflector head, the magnetic pole portion, the connecting piece, and the ground stake.
3. Mode 1: Turn the power switch to the "ON1" position.
4. The PIR (Passive Infrared) sensor is designed to remain on continuously. It uses a 1200mAh 18650 lithium-ion battery.
5. Turn on the switch, and the ultrasonic signal will operate for 30 seconds. Meanwhile, the white light will flash strongly for 30 seconds, and then the product will enter the standby state. This cycle of work continues!
6. Now you can install the product. The installation location should be able to receive enough sunlight to fully charge the battery. Please ensure that the area to be protected is within the working range of the jet.
7. To achieve the desired effect, place the head of the insect repellent device approximately 9-10 inches away from the ground.
8. When installing on a hard surface, please be careful not to squeeze or damage the protection plate. Prepare a grounding stake for grounding to avoid damaging the device.
Mode 2: Turn the power switch to the "AUTO" position.
10. When the infrared sensor detects a signal, the red light will turn on. The emitter will launch ultrasound, and then the white light will flash for 30 seconds. After that, the emitter will return to the standby state.
11. When the device is operating and the infrared sensor detects a signal again, the driver will continue to run for 30 seconds.

Attention:

Let the animal repellent run continuously to pursue the effect.
Do not immerse the repeller in water. Do not cover the PIR sensor.
To clean the vacuum cleaner, please use a soft damp cloth and mild soapy water.
Do not use irritating chemicals or abrasive cleaners.
The reagent may damage the repellent agent.