Galvanized square wire mesh / Iron window screen
Fangyan Network, nets with square holes can be referred to as "square-hole nets"; this is the broad concept of square-hole nets.Welding mesh, yarn nets and others are also considered square-hole nets, but the galvanized square-hole nets we often refer to generally mean iron window screens. These are square-hole wire nets woven from high-quality low-carbon steel wires. Coarse wires that are not galvanized are usually made of black fabric, which then requires galvanization, so the material is generally iron; however, there are also aluminum, copper, and stainless steel wires used in such products.Aluminum window screens<t_copper wire fabric, stainless steel mesh, etc. will be introduced separately later>.
REEDRLON Square wire mesh, the mesh for the square mesh can be referred to as “square eye mesh”. This is the general term for square eye mesh. Electric welding mesh and crimped mesh are also considered square eye mesh. However, when we commonly refer to galvanized square eye mesh, it generally refers to iron window screen. It is made from high-quality low-carbon steel wire woven into square holes. Non-galvanized thick wire is generally black wire cloth, which requires galvanization on the back. Therefore, the material is usually iron. Of course, there are also aluminum wire, copper wire, stainless steel wire, etc., which are called aluminum window screen, copper wire cloth, stainless steel net, etc., and these will be discussed separately later.
Mesh:14*14 16*16 18*18 20*20 24*24 28*28 30*30
Width Wide:1m 1.2m 0.9m 1.5m 0.6m 0.8m 3" 4" 5"
Length: Long:2.5m 30m 20m 15m 10m 100ft, factories usually provide bulk rolls of goods, which are then cut into smaller rolls according to customer requirements.The factory typically has large rolls in stock and cuts them into smaller rolls according to customer requirements.
The method of weaving galvanized eyelet nets generally consists ofedge processing,Welding edge, hold side,Edge wrapping, etc.scalloped edgeThe products produced by the machine currently do not undergo any processing, and there are some burrs without a grid structure.Welding edgeIt is very common nowadays. There are clear signs of high-temperature melting on the edges, and the crossed threads are held together to prevent falling off.Hold the edgeIt is that a small section of wire at the edge, approximately 1-2 cm long, is folded back inside and woven into the net (refer to the previous article).Aluminum window screens). Finally, what was said is...Edge wrappingIt is also the earliest type, the most troublesome and slow to produce, but relatively the most durable. The edge wrapping appears to have no single thread breaking through from one end to the other, then reentering, repeating this process until only one thread remains, ensuring the edge thread does not fall off. Edge wrapping was typically done using old machines in the past. Nowadays, due to slow production capacity and outdated technology, it has been largely phased out. However, there are still some edge wrapping machines for sizes 14 or below.
The processing methods for galvanized square wire mesh are generally divided intorough edge,welding edge,grip edge,wrapping edgeand so on.rough edgeThe machine is currently out of product, and the item has not been processed; there is a burr without a grid.Welding edgeIt is now the most common; the edge wire shows obvious signs of high-temperature melting, and the cross wires are secured together to prevent them from falling off.The edge of the gripIs it that a small section of approximately 1-2 cm of edge wire is woven back inside the net (see the previous Aluminum window screen).wrapped edgeIt is the earliest, the most troublesome, the slowest, and, of course, the strongest. Relatively speaking, it has a good overall appearance. The wire from the head through the department did not break. In the past, a piece of wire was used to ensure the side would not fall off; the wrapped edge was commonly used for old machines. Now, due to the slowness, the basic technologies have been eliminated, but there are still some wrapping machines.
Fangyan Network can be divided into two processing methods based on surface treatment: plating first, then weaving; or weaving first, then plating.FirstplatingafterCompileAlso known as original plating, it involves weaving a net using galvanized iron wire. Generally, the wire diameter is typically 0.3–0.5 mm or higher, and most cases involve weaving first and then galvanizing.First fabricate, then plateIt is done by first applying black silk, and then performing galvanizing treatment. It looks better when the thickness and color are consistent. There are several types of surface galvanizing methods, such as white galvanizing, blue galvanizing, and colored galvanizing.plated whiteIt is standard galvanizing, and the finished color is white.Blue PlatingAlso known as blue-white passivation, the resulting color is blue (as shown in the figure below). It is a processing technique where galvanizing is followed by immersion in a chemical solution to deposit a layer of another metal, thereby enhancing the surface color and rust resistance.Redronfang Eye Net is usually treated with a blue coating.Enhance the service life of the product.Painted with colorsIt is a process where the color is applied as multicolored or golden yellow, mainly due to white zinc being replaced by colored zinc.
The square mesh can bedivided into platingandbraid after platingBy surface treatment. After the first plating, it is also referred to as the original plating. This involves using galvanized iron wire to weave a mesh; generally, the wire diameter is 0.3–0.5 mm or higher. After plating, a 0.3–0.5 mm mesh is woven first, followed by galvanizing. The thickness of the colored layer results in a more attractive appearance. There are also several types of surface galvanization: white plating, blue plating, and colored plating. White plating is a standard galvanizing process, while colored plating is a white-colored coating. Blue plating is also known as blue-white passivation, producing a blue color (as shown in the figure below). This is a process of applying another metal layer in a chemical solution after galvanizing, thereby enhancing the surface color and improving rust resistance. ability. REEDRLON square eye mesh is typically coated with blue plating to extend its service life.Plating colorIs the plating color, or is it mainly white zinc for the color zinc?
The material of Fangyan Network is iron. Although it has been galvanized on the surface, in order to ensure long-term storage, Redron Factory has packaged the product in three layers.Moisture-proof paper insideWrap it in mesh to prevent tearing the outer packaging and avoid hand injuries during handling.Plastic film outsideIsolate air,The outermost two rolls are packaged in a woven bag, to prevent damage to the inner packaging.
Square wire mesh is made of iron; although its surface has been galvanized, in order to ensure long-term durability, it is produced by LeiDeLong factory.Three layers of packagingproducts,waterproof paperInside the screen cover, avoid puncturing or damaging the outer packaging during handling.plasticIsolated from external air, the two packageswoven bagOutside, to prevent the internal packaging from being damaged.
Believe in the power of professionalism!
We recognize Fangyan NetworkReally!
Fangyan NetworkPlease select Redron!
Redron is with you!!!
Believe in the power of professionalism!
We are committed to creating Iron Window Screen!
GoodIron Window Screen, please choose REEDRLON!
REEDRLON with you toghter! !!
