Deduction

1, power on go to zero;

2, place the buckle weights on the scale;

3, pressing the Peel key displays 0.00 , indicates a deduction;

4, then add the items to be weighed, when reading is net items

Press and hold the units m-key until the display CAL;

Press the unit conversion button, then flashing weight value (100.00g);

Place the corresponding weights in scale Central, later, show PASS , and then displays 100.00g , calibration is complete, after you remove the weights, you can carry out weighing.

Notice for use:

1, the largest weighing no more than the maximum amount of drive +2% .

2, overload will permanently damage the product.

3, the product is not exposed to very cold or very hot weather conditions, this product is in a normal environment can work well, prior to use, make products in a new environment fit for at least an hour.

4, prior to use, power on the scale's internal components warm up scales weighing times, this makes weighing precision.

5, place the product in a clean environment, dust, moisture, vibration and air, or electromagnetic interference may have adverse effects on the stability and accuracy of the product.

Troubleshooting:

Weighing the primary factor for inaccuracy or failure low battery, incorrect calibration, overload or operate on non-level surface. Please note that the above mentioned several points, with correct use and maintenance of your product.

1, do not display or displays a low battery symbol " Lo " need to replace battery

2, " EEEEE " overload, overload items should be removed immediately;

3, " o_ld " due to error that scales the internal core part is damaged (for example, impact, dropping or overload), please try the calibration again, if the sensor is not badly damaged, then recalibrate after use.

4, display 88888 , in one plane of vibration, stability