One. Operation:

Put this product in the horizontal plane.

1.短按【ON/OF】或者 开机。

2.显示器显示“0.00”或者“0.0”, 使用【M】或者【Model】键实现单位转换。

3.switch to use of the unit, put the items on the scale weighing.

II. Zero:

1.place a tray or container on the scale.

2.按[T] 或者【TARE】键，显示器将显示“ 0.00 ”  或者 “ 0.0 ”。

3.you can then add items to the container or pallet weighing in.

III. Count function:

Premise of the count function: to count each item weight should be the same.

1.as mentioned above the boot.

2.long press the "PCS" key the display shows sample values25,you can then press the " M/Model" key to switch to another sample value 60,75,100, Then put equal amounts of samples according to the displayed value.

3.press the "PCS" button to complete the sample, and then press the "PCS" button to start counting.

4.item to need to count on the scale, the display shows the exact number of items.

四.Calibration:

This product, manufactured prior to completion of calibration, as this product does not weigh correctly, please calibrate.

Calibration weights used are3000g, 2000g, 1000g, 500g, 300g, 200g, 100g.

1.long press in the boot state "Model" to the monitor is showing 'CAL' and then the monitor will display the calibration weight value.

2.put a weight equal to the calibration weight value, and then press the "on/off" the display shows[PASS], and calibration completed, return to normal weighing status of this product.

If the product shows boot "out2", please refer to the following method calibration this product.

1. this product off of the boot.

2. while holding down the "[ON/OFF]" key and "[MODE]" until a set of numbers appears on the display, then press the "[ON/OFF]" button, the display will display "CAL" Then the monitor will display a calibration weight.

3. will be displayed on the monitor as the weight of the weight on the scales of the Central, and then press the[on/off]key.

4. the display shows "PASS",this product is back in normal weighing conditions, calibration is complete.

五.Troubleshooting

Inaccurate weighing, the major causes of failure: the battery power is low, does not have the correct calibration, weighing items over the maximum amount of this product or not in operation on the plane.

[DISPLAY]Removing errors

"OUT2" new calibration

[EEEE]Overweight, should immediately remove overweight items.

[UN2T]Inequality, need to put this product in use on a level surface.