The baler consists of the body and pliers.

1. Place the baler flat on the bag body, lift the back fuselage and move it to the back top.

2. Tape or plastic tape (hereinafter referred to as packing tape) is applied to the package. One end of the packing tape is pressed at the front pressure and the other end is pressed

Press back on the underfoot, then turn the handle back and forth to tighten the package.

3. Cut the excess packing belt with a knife, put the iron button on the joint of the packing belt, and then use pliers on the button

Tight tie, into a concave - convex shape.

4. Lift the handle back so that the baseboard is lifted and the foot is pressed back. At the same time, the front and rear stabbing claws are disengaged by the handle pressure and the gear, and then the front

Press foot handle down, this time the baling machine and packing belt have been released, the body can be removed.

Maintenance and notes:

1. The machine adopts the mechanical principle, so it must be kept clean and lubricated regularly to reduce wear.

2. The width of the used packing belt is 12~16 mm and the thickness is about 2 mm.

3. Fasten the packing belt by the head. Lift the handle first when taking out the fuselage.