X Email Mobile
EXW Price: |
|
Main Products: |
Strapping machine,carton sealing machine |
Contacts: | chen qingguanChat |
Mobile: | 86-13085670851 |
E-mail: | 932196406@qq.com |
WeChat: | 13085670851 |
Address: | 20862 , 2 F, Yiwu Production Material Market. |
Electronic LCD temperature control, control 0-999 seconds, adjustable pressure;
Heating plate titanium fluoride release liner;
Floor filled with imported high temperature silicone, temperature resistant to 350 degrees the same type.
Technical specifications
Voltage (v): 220-110
Power (kW): 1.0
Temperature range (℃): 0-399
Control range (Sec): 0-999
Dimensions (cm): 52x26x60 cm
Complete machine weight (kg): 16 kg
Operation
① plugged in, turn on the power switch, then the power LED light; (Note: the machine must have the appropriate and secure the protective ground wire)
Secondly, adjust the thermostat to the desired temperature (usually 120-200 ℃);
③ timers to be adjusted to the desired time (typically 5-20 seconds);
④ substrate under the flat on the ironing board, fold again on heat transfer paper (note that heat transfer paper on opposite sides), the handle firmly until the end (Note: do not exceed 30 kg, otherwise it may cause the handle Variant. )
⑤ When indicates the timing when it's time to stamping, buzzer will handle up to back in place;
⑥ tear if it is cold, heat transfer paper, please balance heat transfer paper with a Eraser rub it again, 5-20 seconds, only heat transfer paper torn off. If it is hot-tearing of heat transfer paper, hot stamping, heat transfer paper printing is completed immediately and be torn off. Successful printing needs to have the correct time, temperature and pressure with the thickness and the material of the clothes and the type of heat transfer paper affects the printing results. (Need to try all kinds of heat transfer paper used for sample approval, before mass production. )
Maintenance
1. When printing is complete, when the handle to lift the struggling, over the adjustment screw to increase pressure, if pressure is not enough or too much, after the adjustable pressure nut, to the (+) direction means additional pressure to the (-) direction, namely, to reduce stress.
2. Time: buzzer keeps ringing when stamping time arrival or ring continuously, check the Microswitch inside the boot touching point is the right distance from the, if moderate, shall be adjusted where appropriate.
3. Temperature: when adjusting the temperature arrives, the thermostat reaches temperature, (approximately 15 minutes to 180 deg c), such as when power on for a few minutes and the heating plate is not heating, check the circuit.
4. When you press down on the handle, hands off the handle to automatically pick up, place the adjustment screws for an upward adjustment.
TOP
Items have been added to the Inquiry Basket
There are items in the inquiry basket