！！！USEFUL NOTICE FOR USAGE！！！:

1.Thread in correct way,make sure each step must be followed exactly,please refer to the below.

NOTE:It's very IMPORTANT to thread correctly.If the thread is inserted incorrectly,it may result in the machine seizing up,the thread grouping,the thread becoming unable to be drawn up,etc.

2.Everytime,after threading done,double check if the machine is properly threaded:Raise the presser foot,put the upper thread under the foot,then pull the thread to see if the thread go through smoothly;if not,re-thread and check again.Make sure the threading go smoothly before start sewing.

3.Replace the bottom thread with a full well winded bobbin.

Put the bobbin on the bobbin winder pin, wind thread clockwise around bobbin several times. Push bobbin to the left.Switch on the machine to start winding.Switch off the machine to stop winding after appropriate volume of thread you wanted had winded on bobbin. Push bobbin away from bobbin winder stop, take bobbin off the pin and cut the thread.

NOTE:Please make sure there is no thread in the needle position while winding the bobbin.

4.Make sure the needle installed correctly,the flat side faces to the needle bar,push the needle all the way up,then tighten the screw.

5.Place the fabric under the presser foot,do not running the machine without fabric under the presser foot in case of damaging the machine.

6.Before turning on the switch,rotate the hand wheel to sew 2-3 stitches,make sure there is no jam in thread.Please rotate the hand wheel anticlockwise as the arrow direction;normally,don't rotate the hand wheel clockwise.

7.Never change the stitch type when sewing.Turn off the switch and raise the needle above the needle plate,then change the stitch type,otherwise,needle may bent or break.

8.Switch off the machine when using the foot pedal.

9.Turn off the machine timely when sewing to edge of fabric.

10.Switch off the machine immediately once the thread break or run out off the needle eye or stucked in the bobbin case.

11.Take away the thread top thread when rewinding.

12.The maximum sewing thickness is about 2.5mm,not suitable for over-thickfabric.

Note:If thread is seized up,please immediately stop the machine,cut off power,gently pull out the winding thread and make it smooth,then re-start to sew.Never turn hand wheel and pull thread forcibly,otherwise,the machine will broke.