502 adhesive is mainly alpha-cyanoacrylate, adding viscosifier, stabilizer, toughening agent,The polymerization retarderAnd so on, through the advanced production process synthesis single component instant curingadhesive.

Method of use

 1, first clean then the surface, remove the dust, grease, rust, etc., then on the metal, it is best to first ground coarse, to PE, PP or PTEE plastic, should first make the surface activation.

 2. Open the front cover, and gently button the tip with your finger to leave no residual liquid, and then cut holes with scissors.

 3, in the surface to be followed by a small drop of adhesive, immediately followed, and keep until hardening, then the area should not be too large, then the thickness of the layer should not exceed 0.2mm.

Matters needing attention

 1. The vapor of this adhesive may irritate the mucous membrane and eyes.

Remove method

 1. Use a hot wet towel to stick 502 there. After more than ten minutes, the solidified 502 will become soft and can be removed.

 3, with insulation oil, pour the insulation oil in the transformer on the table, 502 glue quickly soft, can be quickly rubbed off.