The following cases: Oriental Wenhua hotel, Jiangshan, Quzhou

[Material]: oak frame
[Outer packaging]: wooden frame packaging
[Color]: Picture color (color can be customized)
[Inventory situation]: the customization cycle of conventional products is 7-10 days, and the customization cycle of customized products is 15-25 days, which is determined according to the number of products and the manufacturing process.
[Maintenance instructions]: Use a cleaning cloth with detergent or neutral soap solution to remove dust. Note that furniture should not be soaked in water, exposed to the Sun, hit hard, etc.

Contact number: 13735713828 WeChat: 13735713828

process supplementary note

 1. High temperature and high pressure cooking, air drying, steam drying. High temperature and high pressure cooking extracts high moisture content and residual glue juice from wood. Steam drying enables logs to achieve the moisture content required for making furniture, and at the same time achieves the effect of sterilization and insect removal. The treated logs will not be deformed, moldy, decayed and insect, and the moisture content is basically below 12%. At this time, the wood surface mask is glossy, color uniformity, fine texture, and structured to the middle.

  Second, drying treatment is the first step in furniture manufacturing and also a key step. How to deal? -- Steam drying treatment. The drying process is divided into three steps:

  1. Pre-heat treatment: it is mainly low temperature and high humidity to balance the internal and external temperature of wood and preliminarily reduce the moisture content;

 2. Drying stage: mainly gradually raise the temperature, slowly lower the humidity, extract the moisture inside and outside the wood, and make it reach the moisture content we want;

  3. End treatment: after re-treatment, the wood is consistent inside and outside and can be at normal temperature to eliminate the internal stress generated during the drying process. 3. Machining 1. Wood ingredients processing

   after drying the solid wood raw materials, go to the solid wood ingredients processing place through: a: breaking/cutting; B: digging saw; c: flat planing/four-sided planing/pressing planing; d: assembling; e: digging data/longitudinal cutting saw/guide saw; f: milling machine; g:(Profiling) lathe; h: doweling/drilling; I: Slot broaching/carving/sanding. Plate ingredients Processing: a: Ingredients/with veneer/stitching/Mosaic; B: Rough cutting/clamp/framing; c: cold pressing/hot pressing; d; Fine cutting/clip edge sealing/trimming; e: coarse sand/fine sand; f: line/edge sealing; g: Drill/bench drill; h: single end milling machine/double end milling machine; I: Processing Center/Sand cleaning/manual edge sealing.

 ① be firm, sentence, secret, flat and positive.

 ② pay attention to the water content of all solid wood parts and wood carving used must be strictly controlled.

 ③ bad phenomena such as bending deformation and cracking of parts shall be selected and dealt.

 ④ pay attention to the matching of wood grain directions such as panels, side panels, door panels, and pumping panels, as well as the matching of patterns left and right, and try to coordinate the colors.

 ⑤ check whether the mold is loose and worn when the half group is set up.

 ⑥ when the group is set up, there should be no bad phenomena such as anti-installation, wrong installation, violent nailing, locking cracking, dislocation, etc.

Contact number: 13735713828 WeChat: 13735713828