【 please read the following instructions carefully before using]]

1, before using, please check whether the voltage of the LED strip is the voltage you need. All voltages usually include 220V and 110V.

2, LED light strip can only be used with power cord with converter (rectifier Bridge);

3, the LED patch lamp beads of the LED light strip have positive and negative poles. Pay attention to the difference between the polarity of the light body when installing. If the polarity on the wire does not correspond to the polarity on the light body, the light body cannot be lit. Please try again in another direction;

4, do not use a hammer or any metal tool to knock or clamp the light strip, or stretch it too much, because it may cause a section of light to be off, or even the whole strip to burn;

5, before construction, especially in winter, light up the light strip for a few minutes, and then construct after the light strip is hot;
6, if the LED light strip needs to be cut off, please cut it in the middle of the interval of each meter of the light strip (if you cut it at will, it will cause one meter to not light up);
7, if the light strip is installed outdoors, the front connector, intermediate head and end insert must be coated with silicon sealant waterproof to avoid short circuit caused by heavy rain;

8, when the LED strip lights up, because the resistance will heat up, it must not cover the objects tightly, so as to avoid the melting and burning of the strip caused by the heat cannot be scattered;

9, LED strip cannot be installed in the pool (unless otherwise specified)