Cutting maching features: when the punching head acts on the processed object through the cutter die, the pressure in the acting cylinder does not reach the rated pressure, and the pressure will increase with the increase of contact time (cutting into the working object), until magnetic exchange valve receives the signal, the reversing valve changes direction, and the punching head starts to reset; At this time, the pressure in the oil cylinder may not reach the set rated pressure value due to the limitation of the pressure oil time entering the oil cylinder; That is to say, if the system pressure does not reach the design value, punching has been completed.

Cutting maching scope of use: suitable for foaming materials, cardboard, textile, plastic materials, leather, rubber, packaging materials, floor materials, carpets, fiberglass, non-metallic materials such as Cork can be punched and cut through the tool die with the help of ram pressure generated by the machine.

How to set the tool die:

1. Remove the sundries on the workbench rubber sheet and place the knife mold in the center of the rubber sheet.

2 "after the machine starts, loosen the set handwheel and turn the" pressure system "left to zero.

3 "rotate the setting switch right to the direction of" knife mold setting ", and the cutting pressure plate 13 will stop automatically when it starts to go down slowly until the knife mold is attached tightly.

4 "push the setting handwheel below and tighten it. Reply to the 04 setting switch (left-hand) before start to the "cut" position.

5. Press brake switch again, and the cutting pressure plate will immediately rise to the high position. At this time, the knife mold is set.

How to adjust the cutting point:

1 "after the tool die setting is completed, put the cut material on the rubber sheet, then put the tool die on the material, and then push the feeding plate into the cutting area.

2 "press the 12 cutting switch with both hands respectively. At this time, the cutting pressure plate drops and presses on the cutter die, and automatically rises to the position before starting after the cutter die cuts off the material.

3 "when blanking materials, if it is found that the materials are not completely cut, adjust the 03 cutting depth controller to rotate the" pressure system "clockwise and reverse direction; If the knife die is pressed into rubber sheet too deep, then rotate the pressure system in the counterclockwise direction. The longer the adjustment time, the deeper the cutting depth. Try to adjust it until the knife die is slightly pressed into rubber sheet.

4 "pull the feeding plate out of the cutting area, take out the cut materials, and complete a blanking process.