Handbag bag cutting maching when the punching head acts on the processed object through the cutter die, the pressure in the acting cylinder does not reach the rated pressure, and the pressure will increase with the increase of contact time (cutting into the work object), until magnetic exchange valve receives the signal, the reversing valve changes direction, and the punching head starts to reset; At this time, the pressure in the oil cylinder may not reach the set rated pressure value due to the limitation of the pressure oil time entering the oil cylinder; That is to say, if the system pressure does not reach the design value, punching has been completed.

Cutting maching scope of use: suitable for foamed materials, cardboard, textile, plastic materials, leather, handbags and bags, 'rubber, packaging materials, floor materials, carpets, fiberglass, non-metallic materials such as Cork can be punched and cut through the tool die with the help of ram pressure generated by the machine.

How to set the tool die:

1. Remove the sundries on the workbench rubber sheet and place the knife mold in the center of the rubber sheet.

2 "after the machine starts, loosen the set handwheel and turn the" pressure system "left to zero.

3 "rotate the setting switch right to the direction of" knife mold setting ", and the cutting pressure plate 13 will stop automatically when it starts to go down slowly until the knife mold is attached tightly.

4 "push the setting handwheel below and tighten it. Reply to the 04 setting switch (left-hand) before start to the "cut" position.

5. Press brake switch again, and the cutting pressure plate will immediately rise to the high position. At this time, the knife mold is set.